Loading ...
Loading ...
Loading ...
34
INERRUPTING AND CHANCHING
THE PROGRAM
351677
If a power failure occurs when the drum is still full of water, be
careful not to open the door before you pump the water out.
(see Programs/partial programs: Spinning/pumping).
Manual (physical) termination
The program can be cancelled / terminated
by rotating the program selector dial (1) to
the position. “0FF” position.
If there is water in the machine, select the
additional program (spin (+ ) key (4)).
Personal settings
You can change the original settings of
each program. Once you select a washing
program and additional functions, you may
save (store) such combination by pressing
the START/PAUSE key and keep it pressed
for 8 seconds. S C will appear on the
display.
The program will remain stored until it is
changed (using the same procedure).
PAUSE KEY
The program can always be stopped by
pressing the START/PAUSE. If there is no
water in the drum, the door can be opened
after a while; otherwise, the door cannot be
opened. To resume the program, press the
START/PAUSE key.
FAULTS
In case of a fault, the program will be
interrupted. Flashing signal lights and
an acoustic signal will warn about such
occurrence (see section Troubleshooting),
and the fault will be indicated on the display
(E).
Power failure
At electric cutout the program is
interrupted. When the power supply is re-
established, press the START/PAUSE key
to resume the washing program. Delay time
will not be reset.
Washing time will resume from the point at
which it was interrupted.
Loading ...
Loading ...
Loading ...