Loading ...
Loading ...
Loading ...
X Error message X What to do when...
Troubleshooting
Message Cause / Remedy
Low
Battery!
The batteries are weak.
If using AAA alkaline batteries: Replace them
with new ones.
If using Ni-MH batteries, charge them fully.
Battery
Dead
The installed batteries are running low.
Invalid!
selected [Numbering].
is selected for [Numbering].
Tab Length]
or [Label Length].
length while using the Deco Mode or Name
Label function.
No Text!
data stored in the memory.
Numbering], [Mirror],
entered while using the Deco Mode or Name
Label function.
Line Limit!
installed. Install tape of a larger size.
No
Cassette!
There is no cassette installed.
Cutter
Error
middle of the printing process.
Text Full!
entered.
Text Limit!
When using Deco Mode or Name Label
templates:
Since the number of entered characters
In general:
Since the number of entered characters
select [Auto] as the label length.
No Frame OK?
Frame setting ON.
to cancel.
OK to Feed?
Chain
Print] is selected. Refer to the Setting
Margin section in this guide.
Insert
0.47"
for Deco Mode or Name Label templates.
Wrong Tape!
Problem Solution
The display
stays blank
turned on the
label maker.
inserted.
connected.
When the label
is printed out,
there is too
much margin
Setting Margin section in this
guide and select [Half] or [Narrow
smaller margins for your label.
The label
maker does not
print, or the
printed
characters are
not formed
properly.
inserted correctly.
correctly.
The setting has
cleared on its
own.
settings will also be cleared.
A blank
horizontal line
appears
through the
printed label.
an up-and-down motion.
The label
maker has
nothing
happens when
a key is
though the label
Resetting the PT-D201CS
section in this guide.
The power
turns off when
you try to print.
inserted.
The tape does
not feed properly
or the tape gets
stuck inside the
label maker.
the tape guides.
during printing.
format settings
need to be
cleared to create
a new label.
[Text&Format].
To change
language
setting.
Initial Settings section in this
guide.
Loading ...
Loading ...
Loading ...