Loading ...
Loading ...
Loading ...
6
Burner ports: Check burner flames occasionally for proper size
and shape. A good flame is blue in color, not yellow. Keep this
area free of soil and do not allow spills, food, cleaning agents or
any other material to enter the burner ports.
Standard burner
A. Low flame
B. High flame
Dual flame burner
A. Simmer flame
B. High flame
To Clean:
IMPORTANT: Before cleaning, make sure all controls are off
and cooktop is cool. Do not use oven cleaners, bleach or rust
removers.
1. Remove the burner cap from the burner base and clean
according to “General Cleaning” section.
2. Clean the gas tube opening with a damp cloth.
3. Replace burner bases and burner caps.
IMPORTANT:
■ Be sure that the igniter electrode aligns with the slot or
notch in the burner base. The igniter electrode is ceramic
and could break during installation of the burner base.
A. Burner cap
B. Igniter electrode
C. Burner base
■ Be sure that the cap is properly positioned on the burner
and that you have placed the cap on the correct burner.
The ring on the bottom of the cap will align with the tabs
on the burner. Do not interchange caps.
Dual flame burner cap (2) Large burner cap
Small burner cap
4. Turn on the burner. If the burner does not light, check burner
cap and base alignment. See “Burner installation” in the
“Sealed Surface Burners” section. If the burner still does not
light, do not service the burner yourself. Contact a trained
repair specialist.
A. Correct
B. Incorrect
Melt Cap
For melting chocolate or butter or an even more delicate simmer,
the melt cap can be used in place of the standard burner cap.
The melt cap should only be used on the small burner (right
front). Remove the small burner cap and replace it with the larger
melt cap for delicate simmering. For less delicate simmering, use
the small cap.
Surface Grates
Each side grate has one shorter arm that faces the mating grate.
Each burner has a locating ridge on the cooktop surface that
mates with the bottom of the surface grate. To install the burner
grate, align the burner grate so the rubber feet of the grate
are aligned with the 45° corners of the porcelain pad. Evenly
and gently lower the burner grate onto the cooktop surface.
Ensure the four rubber feet of the surface grate are contacting
the porcelain pad. If all four feet are not touching; remove the
surface grate and ensure that the mating surfaces are debris-
free. Reinstall burner grate.
NOTE: On 36" (91.44 cm) models; the center surface grate is
different than the left and right grates.
A
B
C
A
B
A
B
A
B
B
Medium burner cap
A
A
A. Short grate arm
(36" [91.44 cm] model shown)
A. Short grate arm
(36" [91.44 cm] model shown)
Loading ...
Loading ...
Loading ...