Loading ...
Loading ...
Loading ...
34
EN
After the 3 - 2 - 1 countdown, 0:01 s
dsplayed, close the door of the product
and wat for the dranng process
complete. Dranng s completed n
2 mnutes and the machne gves an
audble warnng when t s completed.
C There might be residues of
detergent or rinse aid in the
machine and/or on the pieces being
washed depending on the step the
programme you have cancelled was
in.
Salt ndcator ( )
Please check the salt ndcator on
the dsplay to see whether there s
adequate amount of softenng salt
n the dshwasher or not. You need
to refll the salt reservor wth salt
whenever salt ndcator appears on the
dsplay of your machne.
C Adjusting the water hardness level
is explained in Water Softening
System section.
Rnse Ad ndcator ( )
Please check the rnse ad ndcator
on the dsplay to see whether there
s adequate amount of rnse ad n the
dshwasher or not. You need to refll
the rnse ad reservor wth rnse ad
whenever rnse ad ndcator appears
on the dsplay of your machne.
End of programme
C When the programme you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine. This
audible signal will warn you with
certain intervals before it turns off.
C End of Programme indicator
will light up when the washing
programme is over (Depends on the
model).
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the tap.
4. Unplug the machine from the
socket.
C For energy saving, the machine is
automatically turned off following
the completion of the programme
or if the programme is not started.
C Leave your dishes in the machine
for about 15 minutes to allow them
cool down after they are washed.
Your dishes will dry in a shorter
time if you leave the door of your
machine ajar during this period.
This process will increase the drying
effectiveness of your machine.
Water cut-o warnng
If mans water s cut or water nlet
tap s turned o the machne cannot
take water n and E:02 con wll ash
on the programme ndcator. As long
as the problem contnues, washng
programme s paused and the water
nlet s checked regularly by the
machne; when the water s restored
E:02 con wll dsappear after a whle
and the washng programme resumes.
Overowng warnng
If the machne ntakes too much
water or there s leakage at any of
the components then the machne
wll detect ths and E:01 con wll ash
on the Programme ndcator. As long
as the overowng contnues safety
algorthm wll be actve and try to
dscharge the water. If overowng
stops and safety s assured, E:01
con wll dsappear. If E:01 does not
dsappear, there s a permanent fault.
In ths case the authorsed servce
should be contacted.
Loading ...
Loading ...
Loading ...