Loading ...
Loading ...
Loading ...
en Positioning and connecting
32
■ Do not use the machine with an
extension box, extension cord, spike
busters etc., as this may lead to
improper grounding conditions.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
■ The washing machine must be
correctly installed and connected
~ Page 26
■ Never use a damaged machine.
Inform your after-sales service.
~ Page 24
1. Check the machine.
2. Remove the protective film from the
control panel.
3. Connect the mains plug.
4. Turn on the water tap.
5. Close the washing machine door (do
not load any laundry).
6. Select the l Drum Clean
programme.
7. Open the detergent drawer.
8. Pour approx. 1 litre of water into
compartment II.
9. Pour standard detergent into
compartment II.
Note: To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
10.Close the detergent drawer.
11.Press Start/Pause A .
12.Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1. Turn off the water tap.
2. Reduce the water pressure in the
supply hose.
Maintenance – filter in the water
supply ~ Page 20
3. Drain the remaining detergent
solution.
Maintenance – detergent solution
pump blocked ~ Page 19
4. Disconnect the washing machine
from the mains.
5. Remove the hoses.
Before initial use:
Notes
■ The transport locks must be
removed. ~ Page 28
■ To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour
approximately 1 litre of water into
compartment II and select and start
the Drain [ programme.
Loading ...
Loading ...
Loading ...