Loading ...
Loading ...
Loading ...
Positioning and connecting en
31
Notes
■ With a cold water connection, only
operate the washing machine using
cold mains water.
■ With a hot water connection, operate
the washing machine with hot and
cold mains water, with a maximum
temperature of 60 °C.
■ Do not connect the machine to the
mixer tap of an unpressurised hot-
water boiler.
■ Do not use a used supply hose. Only
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
■ Do not bend, squash, modify or cut
through the water supply hose
(otherwise its strength is no longer
guaranteed).
■ Only tighten the screw fitting by
hand. If the screw connections are
tightened too much with a tool
(pliers), the thread may get
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow
rate is at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Cold water connection
Note: With a cold water connection,
only operate the washing machine using
cold mains water.
Connect the water supply hose to the
tap (26.4 mm = ¾") and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
■ Model: Standard
■ Model: Aqua-Secure
■ Model: Aqua-Stop
Note: Turn on the tap carefully,
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.
Hot and cold water connection
Notes
■ With a hot water connection, operate
the washing machine with hot and
cold mains water, with a maximum
temperature of 60 °C.
■ Red hot water supply hose on the
hot water tap and red valve on the
appliance
■ White cold water supply hose on the
cold water tap and white valve on
the appliance
Loading ...
Loading ...
Loading ...