Loading ...
Loading ...
Loading ...
6 7
The electric controller is located outside the unit on the
bottom, right-hand side front plinth.
It looks like this:
During normal operation the controller display
will
show the temperature inside the refrigerator.
A small indicator light
will illuminate under the ‘cooling’
symbol to confirm the fridge is in its normal cooling mode,
and compressor is running.
Operation of the controller
To set the desired temperature of the fridge
• Press the
button once. A ‘beep’ will sound, and the
display will start to flash.
• Use
buttons to set to the desired temperature.
• Press
again to complete the operation, or just leave
it for 5–10 seconds, and the display will revert back to
showing internal temperature, while new settings saved.
ELECTRIC CONTROL
ELECTRIC CONTROL
ELECTRIC CONTROL
ELECTRIC CONTROL
5
2
1
4
3
1
DOWN control
2
UP control
3
SET control
4
DEFROST control
5
Indicator lights
NOTE: The fridge is built to automatically defrost and prevent
any ice forming on the Evaporator.
It will automatically run a ‘Defrost cycle for 20min once every
8 hours.
When in a ‘Defrost’ cycle, the indicator light will illuminate
under the ‘Defrost’ symbol
To manually activate ‘Defrost’ cycle
• Press the
button and hold it. a ‘beep’ will sound as
soon as pressed.
• Hold button pressed for 10 – 20 seconds, until a second
‘beep’ can be heard.
• The indicator light will now illuminate under the ‘defrost’
symbol and the fridge is into ‘defrost’ cycle.
• ‘Defrost’ will run for 20mins, and then automatically
revert to normal operation.
To manually change back to normal operating mode from
the ‘defrost’ mode
• Press the
button again, a ‘beep’ will sound.
• Hold button pressed for 10 – 20 seconds, until a second
‘beep’ is heard.
• Both indicator lights under the ‘defrost’ symbol and
under the ‘cooling’ symbol will now flash
while the fridge is gearing up to switch back to normal
operation.
• After 5 – 20 minutes, only the indicator light
will
illuminate under the ‘cooling’ symbol to confirm the
fridge is back in its normal cooling mode.
TIPS & INFORMATION
IMPORTANT
• The fridge will go through a normal periodical
defrosting cycle, and a manual defrosting operation is
only require in most extreme cases. It is better to avoid
if not necessary.
• While in the ‘defrost’ mode, the fridge cooling power
is reduced working. The automatic cycles ensure the
defrosting is done in the most efficient manner, a when
required. It is not recommended to leave the fridge in
the manually set defrost mode for prolonged periods of
time.
NOTE: The controller allows you to choose a desired
operating temperature of between -2°C and 8°C.
BeefEater do not recommend to operate the fridge on
settings of below 4°C, as such setting will cause content of
the fridge to freeze, and will result in unnecessary strain on
the cooling systems, and undue high energy consumption.
It is advisable to keep the cover over the controller closed
when not being accessed, so no unintended operation or
damage will occur.
In normal operation the controller turns the compressor off
at the set temperature and back on after the temperature
had risen a few degrees. As such, the reading in the
controller is always a couple of degrees above set-point
and that is perfectly okay.
When the temperature was reached and the compressor is
in its ‘off’ cycle, no indicator light will illuminate.
Loading ...
Loading ...
Loading ...