Loading ...
Loading ...
Loading ...
13
Installing the Clean&Charge Station (see fig. D)
• Remove the protection foil from the Clean&Charge
Station display.
• Using the special cord set (10), connect the
station power socket (12) to an electrical outlet.
• Press the lift button (13) at the rear side of the
Clean&Charge Station to lift up the housing.
• Hold the cleaning cartridge (17) down on a flat,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge from the rear side into the base
of the station until it snaps into place.
• Slowly close the housing by pushing it down until
it locks.
Charging the shaver in the Clean&Charge Station
(see fig. D)
Insert the shaver head down into the cleaning station.
Important: The shaver needs to be dry and free
from any foam or soap residue!
The contacts (7) on the back of the shaver need to
align with the contacts (14) in the station. Push the
shaver in the correct position.
A beep sound confirms that the shaver sits properly
in the station. Charging will start automatically.
Model 5090cc: The Clean&Charge Station analyzes
the hygiene status. The status is shown by the
cleaning program indicators
in the Clean&Charge
Station display (15) more details see chapter
«Cleaning programs» below.
Cleaning the shaver (see fig. D)
When the cleaning indicator lights up in the shaver
display, insert the shaver into the Clean&Charge
Station, upside down and with the front showing (with
released head lock/contact alignment/beep sound).
Cleaning programs
5090cc: The hygiene status will be analyzed and one
of the following program indicators will light up.
short economical cleaning
normal level of cleaning
high intensive cleaning
5070cc/5050cc: One standard cleaning program
included.
Start automatic cleaning
Start the cleaning process by pressing the start
button (16). If status light (15a) does not shine
(Clean&Charge Station switches to stand-by after
ca. 10 minutes), press start button twice. Otherwise
cleaning will not start. For best shaving results,
we recommend cleaning after each shave.
Each cleaning program consists of several cycles,
where cleaning fluid is flushed through the shaver
head. Depending on your Clean&Charge Station
model and/or program selected, the cleaning time
takes up to 3 minutes. During this time the status light
blinks. Leave the shaver in the station for drying.
It takes several hours until remaining moisture
evaporates depending on the climatic conditions.
Afterwards the shaver is ready for use.
After completing the cleaning and charging proce-
dure, all indicators turn off.
Removing the shaver from the Clean&Charge
Station (see fig. E)
Hold the Clean&Charge Station with one hand and
tilt the shaver slightly to the front to release it.
Cleaning Cartridge / Replacement (see fig. F)
When the level indicator
lights up permanently
red, the remaining fluid in the cartridge is sufficient
for about 3 more cycles. When the level indicator
blinks red, the cartridge needs to be replaced -
about every 4 weeks (when used daily).
After having pressed the lift button (13) to open the
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping. Before
discarding the used cartridge, make sure to close
the openings using the lid of the new cartridge,
since the used cartridge will contain contaminated
cleaning solution.
The hygienic cleaning cartridge contains ethanol or
isopropanol (specification see cartridge), which once
opened will naturally evaporate slowly. Each cartridge,
if not used daily, should be replaced after approxi-
mately 8 weeks to ensure optimal disinfection.
The cleaning cartridge also contains lubricants for
the shaving system, which may leave residual marks
on the outer foil frame and the cleaning chamber
of the Clean&Charge Station. These marks can be
removed easily by wiping gently with a damp cloth.
Accessories
Braun recommends changing your shaver’s
Foil & Cutter cassette every 18 months to maintain
your shaver’s maximum performance.
Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette: 52S/52B
• Cleaning cartridge Clean&Charge Station: CCR
• Braun Shaver cleaner spray
Environmental notice
Product contains batteries and/or recyclable
electric waste. For environment protection do
not dispose of in household waste, but for
recycling take to electric waste collection
points provided in your country.
The cleaning cartridge can be disposed of with
regular household waste.
Subject to change without notice.
For electric specifications, see printing on the
special cord set.
97144167_5090cc_MN_S6-76.indd 1397144167_5090cc_MN_S6-76.indd 13 11.09.14 08:1211.09.14 08:12
CSS APPROVED Effective Date 26Sep2014 GMT - Printed 30Oct2014 Page 13 of 76
Loading ...
Loading ...
Loading ...