Loading ...
Loading ...
Loading ...
23
Locating the Filters
Yourrefrigeratorisequippedwithwater
lteringsystem.Thewaterltersystemlters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
Thewaterlterislocatedatthetoprightside
of the fresh food compartment.
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisitour
online store at www.frigidaire.com/store, by calling
toll-free at 877-808-4195, or by visiting the dealer
where you purchased your refrigerator. Frigidaire
recommendsthatyouorderextralterswhenyou
rstinstallyourrefrigerator,andthatyoureplace
yourltersatleastonceeverysixmonths.
Hereistheproductnumbertorequestwhenordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
Replacing the Water Filter
Ingeneral,youshouldchangethewaterlterevery
six months to ensure the highest possible water
quality.TheWater Filter Status light on the user
interfacepromptsyoutoreplacethelteraftera
standard amount of water (200 gallons/757 liters
for PureSource Ultra
TM
)
hasowedthroughthe
system.Thewaterlterstatuslightonthismodelis
notperformancetestedorcertiedbyNSF.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lterbeforereinstallingtherefrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system. Systems
certiedforcystreductionmaybeusedon
disinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
squareinch
• Recommended Minimum Operating
Pressure:30poundspersquareinch
To replace your PureSource Ultra
TM
water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
small amounts of water released during the
lterreplacement.
1 Turn Off the ice maker by raising the wire
signal arm.
2 Removethelterbypushingontheend/
faceofthelter.
3 Slidetheoldwaterltercartridgestraight
out of the housing and discard it.
4 Unpackagethenewltercartridge.Using
the alignment guide, slide it gently into the
lterhousinguntilitstopsagainstthesnap-
in connector at the back of the housing.
5 Push rmly until the cartridge snaps
into place (you should hear a click
as the cartridge engages the snap-in
connector).
6 Turn On the ice maker by lowering the wire
signal arm.
7 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red
to Green, the status has been reset.
8 Afterreplacingthewaterlterandinorderfor
the ice maker to work properly, it is necessary
toclearairfromwaterltertubing.Onceice
maker begins making ice, allow the bucket to
llcompletely,thendiscardtherstTWOFULL
buckets of ice. It will take at least two days
tocompletelyllthebucketonregularice
making mode or 1
1
/
2
days on fast ice mode.
The PureSource Ultra
TM
ice and water
ltersystemistestedandcertiedto
NSF/ANSI Standards 42 and 53 for the
reductionofclaimsspeciedonthe
performance data sheet.
More about your Advanced Water
Filter
CHANGING THE FILTER
NOTE
Ifyourrefrigeratorisequippedwitha
PureSource Ultra
TM
waterlter,itmustbe
replaced with PureSource Ultra
TM
lterULTRAWF.
Loading ...
Loading ...
Loading ...