Loading ...
Loading ...
Loading ...
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal
injury, or damage to the doors or handles.
CAUTION
Drawer is heavy. Use caution when lifting.
10
DOOR REMOVAL INSTRUCTIONS
Once both doors are in place, ensure they are
aligned with each other and level (Please see
the “Installation” section for more details), and
replace the top hinge cover.
Lower Hinge Removal
4 Unscrew the three (3) lower hinge screws
and hinge if necessary.
To reinstall the right door, reverse the above
steps.
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left
sides (two (2) screws on each side).
3 Lift drawer up and out to remove.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer
onto slide brackets ensuring pins on each
side are fully inserted into slots on each side.
6 Tighten four (4) drawer screws.
7 Recheck gasket seal.
8 Installthetoegrillebyttingintoplace.
2 Reinstall four (4) drawer screws (two (2) per
side), tighten down, and close drawer (C).
Assembly
Pin
Slot
Cabinet
Drawer
Fully Extend
Drawer Slides
Install
Screws
(2) Each
Side
3 Check gasket seal around top, bottom,
and sides of freezer drawer.
4 If gasket is not sealed, open drawer and
slightly loosen four (4) drawer screws (two
(2) on each side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
NOTE
You will be pulling approximately three (3)
feet of water tube from the back of the
refrigerator.
Do Not Remove
Other Screws
Remove
hex
head
drawer
screw
Remove
Hex
Head
Drawer
Screw
Remove
hex
head
drawer
screw
Remove
Hex
Head
Drawer
Screw
Grab
Drawer
at
Center
from
Both
Sides
then
Pull
Drawer
Out
Push
Against
Freezer
Drawer
A
B
Loading ...
Loading ...
Loading ...