Loading ...
Loading ...
Loading ...
37
ENGLISH
SPECIFICATIONS
Problem Possible Causes Solutions
Wrinkling
y
Did you remove the load immediately
after it finished?
y
Did you overload the tub?
y
Did you reverse the hot and cold water
inlets?
y
Remove the load immediately after it
finishes.
y
Do not overload the tub.
y
Hot water rinse can cause garments
to wrinkle. Check the inlet hose
connections.
Power is not turned on
y
Is the power cord plugged in properly?
y
Has a house fuse blown, a circuit breaker
tripped, or a power outage occurred?
y
Make sure that the plug is secured in a
grounded 3-prong, 120 V (60 Hz) outlet.
y
Reset the circuit breaker or replace the
fuse. Do not increase the fuse capacity. If
the problem is a circuit overload, have it
corrected by a qualified electrician.
The door does not open
when the cycle pauses or
finishes
y
Is the temperature in the tub too high?
y
Is the water level in washer high?
y
The washing machine has a safety lock
built into the door to prevent burning.
Leave the door closed and wait until
the door lock icon disappears from the
display.
y
Allow the washer to complete the
programmed cycle, or Press the SPIN
button.
The wash cycle time is
longer than usual
y
Is the washing machine overloaded? Are
other options added to the wash cycle?
y
This is normal. The washing machine
automatically adjusts the cycle time for
the amount of laundry, water pressure,
water temperature, and other operating
conditions.
It is musty or moldy in the
tub
y
Has the incorrect detergent been used?
y
Did you clean the tub periodically?
y
Use only HE (High-Efficiency) detergent
recommended for a front-loading
washing machine.
y
See page 30, clean the inside and
outside of the washing machine
periodically.
Banging noise when
washer is filling with water
(Water Hammer)
y
Plumbing in the home moves or flexes
when the water valves in the washer
shut off.
y
Household water supply pressure is very
high.
y
Water hammer is not caused by a defect
in the washer. Install water hammer
arrestors (purchased separately at
hardware or home improvement store)
between the fill hose and the washer for
best results.
y
Adjust household water supply regulator
to a lower pressure or contact a
plumber to have a regulator installed.
SPECIFICATIONS
Model WM4070H*A
Description Front-Loading Washer
Electrical requirements 120 VAC @ 60 Hz.
Max. water pressure 20 – 120 psi (138 – 827 kPA)
Dimensions 68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H), 129.5 cm (D with door open)
27" (W) X 29
3
/
4
" (D) X 38
11
/
16
" (H), 51" (D with door open)
Net weight 200.8lb(91.1Kg)
Max. spin speed 1,300 RPM
Loading ...
Loading ...
Loading ...