Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Before using your equipment
Remove the exterior and interior packing.
CAUTION: After unpacking you MUST allow this unit to stand upright for at least 2 hours to allow
the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may
adversely affect performance and the lifetime of this unit.
Clean the interior surface with lukewarm water, using a soft cloth.
Installation of your equipment
• The unit is designed for free-standing installation and for indoor use only.
• Do NOT store or install the unit outdoors.
CAUTION: This equipment is designed for the storage of medicine or other medical products. Do not
store beverages or perishable food in this unit.
• Place the refrigerator on a floor that is strong enough to support it when it is fully loaded. To level
the unit, adjust the front leveling legs.
• Allow at least 5 inches (127mm) of space between the back, top, and sides of the unit. This
allows the proper air circulation to cool the compressor and condenser for energy saving. The air
vent at the front of the unit must never be covered or blocked in any way.
• NOTE: It is recommended that you do not install the unit near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For
best performance, do not install the unit behind a cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized service
center.
Electrical connection
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a
three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord
supplied. For personal safety, this equipment must be properly grounded.
This unit requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord
is damaged, have it replaced by a qualified electrician or an authorized service center.
Loading ...
Loading ...
Loading ...