Loading ...
Loading ...
Loading ...
18
REMOTE CONTROLLER
1. Operation Display Displays the operation status.
(The figure shows all the statuses.)
• The auto-flap display may be
different, depending on the
installed unit.
2. Start/Stop
button
Pressing this button once starts and
pressing again stops the operation.
3. Fan speed
button
4. Swing/Wind
Direction
button
5. Timer setting
button
Use for operating with a timer.
6. Reset button Use this button after changing the
batteries.
7. Cover Press at the top center and then slide
down.
8. Transmitter
9. Remote control
sensor
Detects the temperature at the
remote controller when detection has
been switched to the remote
controller by the sensor button.
10. Temperature setting
buttons
raises the temperature setting
1°C (1.8°F) at a time.
lowers the temperature setting
1°C (1.8°F) at a time.
11. Filter button CZ-RWSC1U
Press to turn off the filter lamp on the
receiver.
12. Mode Select
button
Press to switch the operation mode.
13. Ventilation
button
Use this when connected to an
aftermarket fan. Pressing this button
starts and stops the fan. When the air
conditioner is started or stopped, the
fan starts or stops at the same time.
( appears on the display of the
remote controller when the fan is
operating.)
14. Address
button
15. Sensor button Use this when switching to detect the
temperature at the remote controller.
At shipping the default setting is set
to detect the temperature at the unit.
At this time is shown on the
display.
16. Clock button Use this when setting the clock.
From this page on the names of remote control
buttons will be abbreviated as the illustration of the
“button”.
E.g.: Start/Stop button
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
163011_SingleSplit_EN_2.fm Page 18 Thursday, September 15, 2011 9:03 AM
Loading ...
Loading ...
Loading ...