Loading ...
Loading ...
Loading ...
Kelvinator gas continuous flow hot water system initial operation 7
Initial operation
4. Turn on the 240 volt 50 Hz power supply to the
water heater.
5. Open a hot water tap or xture and verify that hot water is
now available.
caution
The following process should be completed by the
installer only.
Once all checks have been completed, please clean filter of
any debris. Refer to page 10 for instructions.
1. Fully open the manual water control valve on the water
supply line.
2. Open a hot water tap to verify that water is flowing to
that tap then turn the tap off.
3. Fully open the manual gas control valve installed and
check for leaks.
warning
If you smell gas or a gas leak is detected after opening the
manual gas control valve, immediately close the valve. Do
not turn on power to the water heater and keep potential
ignition sources away. Call a service technician to inspect
and repair the leak.
Loading ...
Loading ...
Loading ...