Loading ...
Loading ...
Loading ...
OCCURRENCE
POSSIBLE CAUSE SOLUTION
WASHER - OPERATING
(continued)
Washer does not start Cycleselector isnot in correct position, Move indicator clockwiseslightly Pull out knob
{continued).
Motor isoverheated. Washer motorwill stop if it becomesoverheated. Itwill
automatically restartafter a cootdown period of up to
30 minutes (if washer has not been manually turned
off).
Washer won't spin. Lid isnot completeEyclosed Closelidcompletely Safetylid iockmust not bebroken,
Residue left in tub. Heavilysoiled items Wipe tub with a nonabrasivehousehold cleanser,then
rinse Shakeor brush excessdirt and sand from items
before washing.
WASHER - WATER
Wash load too wet after Washer isoverloaded. Do not overload washer, SeeWashing Procedures.
spin.
Load isout of balance Rearrangeload to allow proper spinning.
Drain hose iskinked. Straighten drain hose
Water does not enter Water supply is not adequate in area, _ Check another faucet in the house Wait until water
washer or it enters slowly, supply and pressureincrease.
Water supplyfaucetsarenot completelyopen. Fullyopen hot and cold faucets.
Water isbeing usedelsewherein the house., Water pressuremustbe at least30 psi (260 kPa)Avoid
running water elsewhere while washer isfilling,
Water inlethosesare kinked Straighten hoses.
Water level does not cover Improper ,waterlevelselection (for Selecthigher water level/load size°
load. models with water level/loadsizecontrol).
Washer isoverloaded, Donot overloadwasher.When control issetat highest
fifl level, dry load level should not be higher than top
row of circular holesin wash tub
Warm or hot water is not Hot water heater isset too low or isa Measurehot water temperature at nearby faucet with
hot enough, distance from laundry center, candyormeatthermometer,Water temperature should
be at least 130°F (70°C) Adjust water heater as
necessary,
Hot water isbeing usedelsewhere in
the house
Avoid using hot water elsewhere before or during
washer use, There may not be enough hot water
availablefor proper cleaning. If problem persists,your
hot water systemmay be unableto support more than
t useat a time.
Water in washer does not Drain hoseiskinked or clogged Clean and straighten the drain hose
drain or drains slowly.
Water leaks. Fillhoseconnection at faucet or washer Check and tighten hose connections Install rubber
sealingwashers provided.
Housedrain pipes are clogged, Unclog drain pipes,,Contact plumber if necessary
Oversudsing Uselessdetergent
Incorrect wash and rinse Hot and cold water hosesare connected Connect hot water hoseto hot water faucet and cold
temperatures, to wrong supply faucets water hoseto coldwater faucet,
Water is entering washer Drain hosestandpipe isincorrect height, Standpipe must be aminimum of 33" (83,82 cm) high
but tub does not fill, to prevent siphoning, See INSTALLATION
INSTRUCTIONS.
13
Loading ...
Loading ...
Loading ...