Loading ...
Loading ...
Loading ...
8 49-90585
Getting started
USING THE DRYER
O
M
eDry
Reduces the total energy consumption of specific dryer cycles by adjusting certain heat settings.
NOTE: Cycle times will change when e-Dry is selected. The eDry option will default to on
for Cottons. For optimal energy savings, turn eDry on. For optimal drying times, turn eDry off.
Energy savings will vary across loads and cycles.
This cycle can be used with Cottons, Mixed Loads, Towels/Sheets, Delicates, Bulky Bedding,
Perm Press/Casuals and Quick Dry. When the eDry button is pressed, cycle settings change to
reduce the total energy consumption of the selected sensor cycle.
Lock Controls
You can lock the controls to prevent any selections from being made. Or you can lock or
unlock the controls after you have started a cycle.
Children cannot accidentally start the dryer by touching buttons with this option selected.
To lock/unlock the dryer controls, press and hold the eDry button for 3 seconds. A sound is
made to indicate the lock/unlock status. The indicator light above the button will illuminate
when the controls are locked.
NOTE: The Power button can still be used when the machine is locked.
L
N
Clean Filter Message
This message represents only a reminder and does not always appear when the filter needs
cleaning. The filter should be cleaned after every drying cycle is complete.
This message will disappear after the Start/Pause button is pressed. Even though you may
have already cleaned the filter (before or after the Power button has been pressed), the
“Clean Filter” message will still be displayed until the Start/Pause button is activated.
Display
Displays the approximate time remaining until the end of the cycle.
As the cycle begins, you will see an initial approximate total cycle time in the display.
Then lights will “race” in the display. This means the dryer is continuously monitoring the
amount of moisture in the load. The lights will continue until the dryer senses a low level of
moisture in the load. At that point, the dryer will calculate and display the approximate time
remaining.
Volume
Alerts you that the cycle is complete. The beeper will continue to sound every minute for the
next 5 minutes, until the clothes have been removed. The clothes should be removed when
the beeper goes off so wrinkles don’t set in.
Press Volume to select low, medium or high volume, or to turn the beeper off.
To turn on or off the sounds the buttons make when pressed, press and hold the Volume
button for 3 seconds.
Hold To Lock Controls
eDry
P
My Cycle (on some models)
Set up your favorite combination of settings and save them here for one touch recall.
These custom settings can be set while a cycle is in progress.
To store a My Cycle combination of settings:
1. Select your drying cycle.
2. Change Temp and Level settings to fit your needs.
3. Select any drying options you want.
4. Press and hold the My Cycle button for 3 seconds to store your selection. A beep will
sound and the button will light up.
To recall your stored My Cycle combination:
Press the My Cycle button before drying a load.
To change your stored My Cycle combination: Repeat steps 1–4.
My
Cycle
Loading ...
Loading ...
Loading ...