Loading ...
Loading ...
Loading ...
en
6
Installing the appliance
Transport
The appliance must be manoeuvred by a
minimum of 2 persons.
Hold the appliance around its sides or
base when moving it. Under no
circumstances should it be lifted by
holding the edges of the top surface.
Location
The ideal installation location is a dry,
well-ventilated room. The installation
location should not be subject to direct
sunlight or be near a heat source such
as a cooker, heating element, etc. If
setting up the appliance next to a heat
source is unavoidable, use a suitable
insulating plate or observe the following
minimum distances from the heat
source:
■ 3 cm from an electric or gas cooker.
■ 30 cm from oil or solid fuel cookers.
Installation clearances
When installing the appliance, ensure
that 25 mm of free space is left at both
sides, 50 mm at the rear and 30 mm at
the top of the appliance.
Ensure there is adequate space for the
door to fully open.
If the appliance is placed under a
continuous worktop, a ventilation grille
figure " of at least 200 cm
2
should be
installed on the worktop above the rear
of the appliance to increase ventilation.
Floor surface
The floor at the installation location must
not buckle and you may have to
reinforce the floor.
Level out any unevenness in the ground
using support spacers.
Levelling the appliance
Level out any unevenness in the ground
by adjusting the two levelling feet
figure # at the front of the appliance.
Use a spirit level to align the appliance.
If the appliance is not level, the door and
magnetic seal alignments will not be
covered properly.
Changing over the door
hinges
(If required)
We recommend that 2 people handle the
appliance during assembly.
m Warning
While changing over the door hinges,
ensure that the appliance is not
connected to the power supply. Pull out
the mains plug beforehand.
Figure &
Installation in numerical sequence.
Loading ...
Loading ...
Loading ...