Loading ...
Loading ...
Loading ...
Air Conditioner Features
(continued)
HEAT (some models)
The HEAT selection provides quiet, efficient circulation of warm air Turn the
selector to the HEATsetting and set the thermostat to the warmest setting, When
the HEAT setting is selected, the thermostat maintains the temperature by
automatically turning the heater on and off in response to room temperature
Once the room iswarm, adjust the thermostat to a cooler setting, The fan runs
continuously to circulate air in the room
Vent Control - Some Models
A slight heat odor may come from the unit when first switching to HEATafter the
cooling season isover this odor, caused by fine dust particles on the heater, will
disappear quickly
Vent Control
TheVent Control aitowsthe air conditioner to either recircutate inside air (CLOSED)
or exhaust air to the outside (OPEN)
The CLOSEDposition isusedwhen maximum cooling isdesired It may also be
usedfor air recirculation without cooling when the air conditioner isset in the
FANposition
- The OPENposition removes stale air from the room and exhausts it to the
outside Freshair isdrawn into the room through normal air passagesfound
in homes
• The OPENor CLOSEDposition can be used with any fan selectfon
o For compact models, push the slide In to CLOSE.pull out to OPEN
Care and Cleaning
Air Directional Louvers
The air directional louvers control the air flow direction Adjust louvers up, down,
left or right The outside tabs adjust the air up or down The center levers direct
the air left or right
Clean your air conditioner occasionally to keep it looking new, Be sureto unplug
the unit before cleaning to prevent shock or fire hazards
Locking
Tabs
Press firmly on each side of
case to release locking tabs
Figure1
Removing Decorative Front - Some Models
Fronl
Retaining
Screws
Figure 2
SliderCasement Front
Decorative Front and Dial Plate Removal:
1, Unplug power cord from the wall outlet
2 Remove knobs by pulling firmly, and then remove dial plate Remove front
retaining screw from the front (seeFigure 1 or 2 for screw location, whichever
issimilar to your model),
3 Pressfirmly on each sideof the metal caseclose to the front, approximately half
way down for Figure 1;or for Figure 2, 2/3 the way down from the top of the
front.
4 While pressing on the sidesof the meta! case, gently pull the front out and lift
up to release it from the case
1"oReinstall the Front:
Proper reinstaflation of decorative front is important for both safety and
performance
t Position the top of the decorative front on the top flange of the case and align
the tabs on the front with the slots in the case
2 Carefully pull down on the front to engage the top tabs while pushing the front
over the case to ensure proper alignment The side locking tabs wilt "click"
when the front is properly installed,
3 Install the front retaining screw (seeFigure 1 or 2 for screw location, whichever
issimilar to your model)
4 Installthe knobs byaligning them with their shafts and pushing firmly into place.
Loading ...
Loading ...
Loading ...