Loading ...
Loading ...
Loading ...
37
SELF-CLEANING
Step Press
1. The oven should be empty and all
oven racks removed. Remove
all items from the cooktop. Be sure
the oven door is completely closed.
2. Press delay start.
3. Enter 9 0 0.
4. Press start.
5. Press self clean once for a 3-hour
clean time, press self clean twice for
4-hour clean and press 3 times
for a 2-hour self-clean cycle time.
6. Press start to accept.
Example: To program a self-cleaning cycle with a
delay start time of 9:00 o’clock:
Setting a delay start self-clean cycle
1. Press keypad.
2. If the self-clean cycle has heated the oven to a high
temperature, the "Hot" (Fig. 1) message will show in
the display. Allow enough time for the oven to cool and
for the "door OPn" message to display (Fig. 2). When
this message turns off the oven door may be opened.
If it becomes necessary to cancel self-clean:
Restarting a self-clean cycle after a power outage:
If self-clean was cancelled manually shortly after being
started, and the oven interior did not reach high self-clean
temperatures, the next clean cycle may be set as soon as
the oven door unlocks from the cancelled clean cycle.
If the oven became hot enough from the cancelled self-
clean cycle, you may be required to wait up to 4 hours
before the control will allow another self-clean cycle to
start.
NOTES
The maximum delay start setting is 11 hours & 59
minutes.
Check to be sure the oven is empty before setting a
self-clean cycle. Immediately after setting self-clean
with a delay start setting the oven door will lock. The
self-clean feature will not start heating the oven for
cleaning until reaching the delay start time.
If a self-clean cycle was interrupted by a power failure,
your oven may not have thoroughly cleaned. If so, once
power is restored, the oven has cooled and the oven door
has unlocked, if needed, set for another self-clean cycle.
Fig. 1
Fig. 2
Press cancel at any time to stop self-clean.
Starting another self-clean after cancellation:
NOTE
If setting "back to back" self-clean cycles, the control may
display the messages "CLEAn", then "dELAy" followed by
the length of time to wait before the next self-clean may
be set. For example, if the message displayed reads
"4:00", the control will not allow self-clean to be set until
4 hours later.
Loading ...
Loading ...
Loading ...