Loading ...
Loading ...
Loading ...
Operating the appliance en
39
Time preselection
You can delay the start of the
programme by up to 24 hours.
Depending on the setting of the time
display, the end of the programme is
indicated with “Ready in” (for example
3h 25min) or “Finish at” (for example
15:20).
1. Switch on ON/OFF switch (.
2. Select programme 0.
3. Press time preselection button X.
4. Press the setting buttons - + P
repeatedly until the time you want is
shown.
5. Press the START button )", time
pre-selection is activated.
6. To delete the time pre-selection,
press the START button )" for
approx. 3 seconds.
Time pre-selection was terminated.
Programme end
The programme has ended when
“Finished” appears on the front display
)B.
Switching off the appliance
Shortly after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off water supply (does not
apply to appliances with Aqua-Stop).
3. Remove the utensils when they have
cooled down.
Note: When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
2. Switch on the ON/OFF switch (
again to continue the programme.
Terminating the programme
(reset)
Ter mi nat i ng the pr o gr amme
1. Press the START button )" and
hold it down for about 3 seconds.
The front display )B shows
“Programme was terminated”. The
programme sequence lasts approx.
1 min.
The front display )B shows
“Finished”.
2. Switch off ON/OFF switch (.
Changing the programme
When the START button )" has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
Loading ...
Loading ...
Loading ...