Loading ...
Loading ...
Loading ...
Operating Instructions
Safety Instructions
Installation
Instructions
Troubleshooting TipsConsumer Support
28
Care and cleaning of the range.
Burner Caps and Heads
Before removing the burner caps and heads,
remember their size and location. Replace them in
the same location after cleaning.
NOTE: Do not use steel wool or scouring powders
to clean the burner parts.
Burner caps
Lift off when cool. Wash burner caps in hot, soapy
water and rinse with clean water. You may scour
with a plastic scouring pad to remove burned-on
food particles.
Burner Heads and Oval (Center) Burner
Head/Cap Assembly
(on some models)
The burner heads and the oval burner head/cap
assembly are removable. Simply lift them off the
range for cleaning.
For proper ignition, make sure the small hole
in the section that fits over the electrode is kept
open. A sewing needle or wire twist-tie works
well to unclog it.
The slits in the burner heads must be kept clean at
all times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes will not
allow the burner to operate properly.
Any spill on or around an electrode must be
carefully cleaned. Take care to not hit an electrode
with anything hard or it could be damaged.
Clean the burner heads routinely, especially after
bad spillovers, which could clog the openings. Lift
off when cool.
To remove burned-on food, soak the burner heads
in a solution of mild liquid detergent and hot water
for 20–30 minutes. For more stubborn stains, use a
toothbrush.
After cleaning
Before putting the burner caps, heads (on some
models) and oval head/cap assembly back, shake
out excess water and then dry them thoroughly
by setting in a warm oven for 30 minutes.
Replacement
Burner Heads
Replace burner heads over the electrodes on
the cooktop, in the correct locations according to
their size. There is one small, one medium, one
large and one extra large burner head.
Make sure the slot in the burner head is positioned
over the electrode.
Oval (Center) Burner Head/Cap Assembly
(on some models)
Replace the oval (center) head/cap assembly over
the electrode on the cooktop.
Caps
Replace the matching size caps onto the burner
bases or heads.
Make sure that the heads and caps are replaced in
the correct locations.
The oval burner head/cap assembly
is removable. Simply lift it off the
range for cleaning. Use a sewing
needle or twist-tie to unclog the
small hole in the burner heads.
Burner cap is
properly seated.
Burner cap is NOT
properly seated.
Electrode
Slot
Front of range
Oval head and cap
assembly
Medium head
Front of range
Large head
Small head
Extra
large head
Medium cap
Front of range
Large cap
Small cap
Extra
large cap
Slot
Electrode
The burner heads (on some models)
are removable. Simply lift them off
the range for cleaning.
Make sure the slot in the
burner head is positioned
over the electrode.
Burner heads (on some models)
Hole in
burner
head
Slot
Electrode
Loading ...
Loading ...
Loading ...