Loading ...
Loading ...
Loading ...
Fig. 7
u
Lift the stopper
(33)
out of the door bearing bush and
transfer it.
u
Dismantle the door handle
(32)
, stoppers
(33)
and pressure
plates*
(34)
and transfer to the opposite side.
u
When fitting the pressure plates on the opposite side, make
sure they snap properly into place.*
4.3.4 Fitting the door
u
Place the door from above onto the lower bearing pin
Fig. 5 (22)
.
u
Close the door.
u
Insert the upper turn hinge
(12)
in the door on the new hinge
side.
u
Screw the upper turn hinge
(12)
firmly into place (with
4 Nm)(2x Torx® 25)
(13)
. Possibly make preliminary holes
with a bradawl or use a cordless screwdriver.
u
Snap the cover
(10)
and cover
(11)
into place at the oppo-
site side.
4.3.5 Aligning the door
u
Align the door to the appliance housing by way of the two
oblong holes in the bottom turn hinge
Fig. 5 (25)
. To do so,
unscrew the middle screw.
WARNING
Risk of injury due to the door dropping out!
If the bearing parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What is
more, the door may not close and therefore the appliance may
fail to cool properly.
u
Screw the turn hinges firmly into place with 4 Nm.
u
Check all of the screws and retighten if necessary.
4.4 Insertion into a row of kitchen units
Fig. 8
(1) Top cupboard (3) Kitchen cabinet
(2) Appliance (4) Wall
x
For appliances supplied with wall spacers, the measurement
increases by 35 mm (see 4.2) .
The appliance can be built into kitchen units. A top cupboard
Fig. 8 (2)
can be added above the appliance in order to bring
the appliance
Fig. 8 (1)
up to the height of the fitted kitchen
units.
Ventilation requirements:
-
At the back of the stack cabinet there has to be a ventilation
duct of at least 50 mm depth throughout the width of the
stack cabinet.
-
The cross section of the ventilation gap below the ceiling
must be at least 300 cm
2
.
-
the larger the ventilation space, the more energy-saving the
appliance is in operation.
If the appliance is installed with the hinges next to a wall
Fig. 8 (4)
, the distance between appliance and wall has to be at
least 40 mm. This corresponds to the projection of the handle
when the door is open.
4.5 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film!
u
Do not allow children to play with packing material.
The packaging is made of recyclable materials:
-
corrugated board/cardboard
-
expanded polystyrene parts
-
polythene bags and sheets
-
polypropylene straps
-
nailed wooden frame with polyethylene panel*
u
Take the packaging material to an official collecting point.
Putting into operation
* Depending on model and options 7
Loading ...
Loading ...
Loading ...