Loading ...
Loading ...
Loading ...
20
English
4Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
Press (3 raised dots on the Rear panel or Front panel or the
Remote control).
Adjusting volume
To decrease or increase volume
Press VOL / (1 raised dot on the Rear panel) or Front panel
or press VOL + / on the Remote control.
VOL : Volume Down
VOL : Volume Up
To mute or unmute sound
Press on the remote control to mute the sound.
Press again or VOL + / to recover the original sound.
Switching channels
To select Channels by using CH / or CH + /
Press CH (Down) / (Up - 1 raised dot on the Rear panel or
Front panel) or press CH + / on the Remote control.
To select Channels by using the NUMBER buttons
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
* On the 46” & 50” TV’s All CONTROL Keys are located on the Rear
(lower right) side of the unit as viewed from the Front.
Note
Energy consumption contributes to air and water pollution. When the AC power cord
is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
50PFL3908 /
46PFL3908 /
46PFL3608
39PFL2908 /
39PFL2608
40PFL4908 /
32PFL4908 /
29PFL4908
* Key on Rear
50PFL3908 /
46PFL3908 /
46PFL3608
39PFL2908 /
39PFL2608
40PFL4908 /
32PFL4908 /
29PFL4908
* Key on Rear
Note
To select the non-memorized channels, use the NUMBER buttons.
Channel not available or No Signal will appear on the TV screen after the subchannel
broadcast is over.
Audio Only message will appear on the TV screen, when you receive only sound
signal.
50PFL3908 /
46PFL3908 /
46PFL3608
39PFL2908 /
39PFL2608
40PFL4908 /
32PFL4908 /
29PFL4908
* Key on Rear
Digital TV operation
Analog/Cable TV operation
Loading ...
Loading ...
Loading ...