Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
E-4
ENGLISH
When drainage is necessary
Install the cabinet into the installation
opening.(Fig.8)
Secure the cabinet to the mounting frame
using the 9 long gold screws. (2.5cm/1").
(Fig.8)
Stuff the gasket to the gap between the
mounting frame and the unit to seal out-
side air. (Fig.8)
4
(1)
(2)
(3)
Slide the chassis back into the cabinet.
(Fig. 9)
Secure the chassis to the cabinet using
the screw and angle removed in step 2.
Push the angle into the gap between the
chassis and the cabinet. Hook the angle
to the slit of the cabinet, next screw it on
to the chassis. (Fig. 10)
Replace the front panel. (Fig.11)
Slide the crank shaft into the opening of
the louver link at the back of the front panel.
(Fig.12)
Open the grille and secure the front panel
with the screw removed in step 1 (Fig.13).
Replace the air filter and close the grille
firmly.
5
(1)
(2)
(3)
Chassis
Rubbur cap
Fig.6
Cabinet
Drain tray
Fig.7
Cabinet
Gasket
Fig.8
Front panel
Fig.12
Fig.11
Front panel
Grille
Fig.13
Fig.9
Crank shaft
Louver link
Front panel back view
If water drainage is necessary in high humid-
ity district, or if you do not like the splashing
sound of the non-drain function, remove the
rubber cap on the bottom of the chassis. Cut
the rubber cap in cross, working from the bot-
tom and remove the rubber pieces with a
plier.(Fig.6)
A hose of an appropriate length have to be
attached to the drain tray's drain outlet. (Fig.7)
(4)
Angle
Slit
Cabinet
Chassis
Fig.10
Downloaded from: http://www.usersmanualguide.com/
Loading ...
Loading ...
Loading ...