Loading ...
Loading ...
Loading ...
21/23: the grease filters must be cleaned approximately once every 30 hours of operation (when the central
segment on the display goes on or starts blinking). To remove the filters: press inward on the clamps at the
handles and pull the filter downward. Wash out the filter using a neutral soap. Once the cleaned filters are
reinstalled, keep button R (Reset) pressed for two seconds to reset the counter. For further information, see
the Commands in Fig. 21/23 in the paragraph entitled “Operation”. If the model purchased has the commands
shown in Figure 22: the grease filters must be cleaned approximately once every 30 hours of operation (when
the light button lamp comes on) - Fig. 22S). To remove the filters: press inward on the clamps at the handles
and pull the filter downward. Wash out the filter using a neutral soap. Once the cleaned filters are reinstalled,
to reset the counter hold the light button pressed down for about 1” (Fig. 22A) while the corresponding pilot
lamp (S) is on. For further information, see the Commands in Fig. 22 in the paragraph entitled “Operation”.
Replacing the charcoal filters: If the unit is a filtering hood, the charcoal filters must be replaced: to remove
them press inward on the clamp (Fig. 20) and rotate the filter downward until the 2 tabs can be removed from
the housing.
If the model purchased has the commands shown in Figure 21/23, the charcoal filters must be replaced
whenever the central segment of the display starts blinking (i.e. every 120 hours of operation). If the model
purchased has the commands shown in Figure 22, the charcoal filters must be replaced each time the light
button (Fig. 22S) lamp flashes (i.e. every 120 hours of operation).
Lighting: to remove the halogen lamps, turn the locknut counter-clockwise (Fig. 24). Replace with the same
type of lamp.
Loading ...
Loading ...
Loading ...