Loading ...
Loading ...
Loading ...
7
NOTE: Fill amounts shown are for standard powdered detergent.
Follow instructions on the package when using other dishwasher
detergent.
Add Rinse Aid
■ Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
■ Rinse aid keeps water from forming
droplets that can dry as spots or streaks.
They also improve drying by allowing water
to drain off of the dishes after the final rinse.
■ Check the rinse aid indicator. Add rinse aid
when indicator drops to “Add” level.
■ To add rinse aid: Open the rinse
dispenser lid by gently pushing
in the center of the lid with your
thumb and pulling up on the
edge. Pour rinse aid into the
opening until the dispenser is
full. Then, close the dispenser
by pushing down gently on the
lid.
NOTE: For most water conditions, the factory setting will give good
results.
■ Check water hardness level to ensure no
rings or spots on your dishware before
adding rinse aid or adjusting the factory
setting.
■ If you have hard water or notice rings or
spots, try a higher setting.
■ Turn the arrow adjuster inside the
dispenser by either using your fingers or
inserting a flat-blade screwdriver into the
center of the arrow and turning.
Select a Cycle (cycles vary by model)
See “Cycle and Option Descriptions” charts in the following
section.
Heavier cycles and options affect cycle length.
Select Options (options vary by model)
See “Cycle and Option Descriptions” charts in the following
section.
You can customize your cycles by pressing the options desired.
Start or Resume a Cycle
■ Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water. For best dishwashing results, water
should be 120ºF (49ºC) as it enters the dishwasher.
■ For models with controls on top of the door, select wash cycle,
option and press START/RESUME before closing the door.
Push door firmly closed. The door latches automatically. Select
the wash cycle, options and press START/RESUME or press
START/RESUME to repeat the same cycle and options as in the
previous wash cycle.
■ You can add an item anytime at the beginning of the cycle.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
Soft Water
Hard Water
Main Wash Pre-Wash
Full
Add
Pre Wash
OPEN
S
LIDE
STEP 3
STEP 4
Loading ...
Loading ...
Loading ...