Loading ...
Loading ...
Loading ...
28
SQT0126
Reference
Troubleshooting guide
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
∫ Unit does not respond to remote
control or unit’s buttons.
Disconnect the AC mains lead, wait 1 minute,
then reconnect the AC mains lead.
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
∫ Cannot eject disc.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
4 Press [OK].
To return to the factory defaults.
¾ Select “Yes” in “Default Settings” in the Setup
menu. (> 27)
To return all settings to the factory preset.
¾ Reset the unit as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
4 Press and hold [OK] for more than 5 seconds.
The remote control does not work properly.
¾ Change the batteries in the remote control.
(> 5)
¾ The remote control and this unit are using
different codes.
Press and hold [OK] and the displayed
number (“”) for more than 5 seconds.
The TV tuner mode is not displayed when the
TV is turned on.
¾ This phenomenon may occur, depending on
the TV setting, when “Quick Start” is set to
“On”.
¾ Depending on the TV, this phenomenon may
be prevented by reconnecting the HDMI cable
to a different HDMI input terminal or by
changing the HDMI auto connection setting.
You have forgotten your ratings password.
You want to cancel the ratings level.
¾ The ratings level returns to the factory
defaults.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
4 Press [OK].
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are
enjoying the latest technology. (> 13)
– [BDT260] [BDT161] [BDT160] Image disturbance
when replacing 3D discs.
– POWER LED starts to flash, and “00RET”
is displayed on the screen.
3 Press [1] (right) repeatedly on the remote
control until “06FTO” is displayed on the
screen.
General operation
– POWER LED starts to flash, and “00RET”
is displayed on the screen.
3 Press [1] (right) repeatedly on the remote
control until “08FIN” is displayed on the
screen.
Turn on this unit by using the standby/on
switch on this unit, and check “Remote
control ”, which is displayed on the screen
when you press a button on the remote
control.
– POWER LED starts to flash, and “00RET”
is displayed on the screen.
3 Press [1] (right) repeatedly on the remote
control until “03 VL” is displayed on the
screen.
DMP-BDT260&161&160&BD91&81_EBGNGCGAGW-SQT0126_eng.book 28 ページ 2014年2月28日 金曜日 午前10時44分
Loading ...
Loading ...
Loading ...