Loading ...
Loading ...
Loading ...
802269 - Residential CS & CSHA User Manual - 09.2016 - v3.01 Page 21 of 28
LCD Screen operation - Section G
Sleep Mode
Light
Level
Time
Delay
State Chiller
2 Hours-> OFF N/A 2 Hr OFF OFF
Lux Sensor-> OFF Dark N/A OFF OFF
Lux or 2 Hr-> OFF Dark 2 Hr OFF OFF
Disable N/A N/A ON ON
This mode allows the HydroTap to enter into an Energy Saving mode. There
are two options available: ‘Sleep’ mode and ‘ON/OFF’ mode.
To activate the sleep mode:
1.
Press [MENU] button for main
menu.
2.
Press [Setting] button.
3.
Press [Energy Modes] button.
4.
Press [Sleep Modes] button then
in the next screen, use the up and
down arrows to select one of the 4
options as shown in the table below.
Energy Modes
In SLEEP MODE the unit will go to “Sleep” after a 2hr period of inactivity.
The Chilled water will be ON or OFF.
When the period of inactivity passes, the home screen status window will
show “Sleep Mode”.
Lux (Light) Sensor Calibration:
It is recommended to recalibrate the Lux (Light) Sensor after selecting any
of the Lux sensor options from the sleep mode menu. Before commencing,
ensure there are ‘Normal to Dim’ (Not Dark) operating light conditions.
Note:
Refer to section C4 for calibration procedure
Note:
Any attempt, during OFF mode, to dispense water, will bring the unit
out of sleep mode. The unit will return to sleep mode after 2 hours of non
use. Please allow sufficient time for the water to reach the set temperature
after disabling the sleep mode.
Loading ...
Loading ...
Loading ...