Loading ...
Loading ...
Loading ...
802269 - Residential CS & CSHA User Manual - 09.2016 - v3.01 Page 15 of 28
1.
Press the [MENU] button for main
menu.
2.
Press the [Install] button. Turn the
stop cock ON.
3.
Press the [Filter Flush] button.
4.
Press [Start] [Stop] buttons to start
and Stop the filter flush. Once the
filter flush is finished, Turn the stop
cock OFF first (to ensure the cock is
properly closed) then press [Stop]
to end filter flush mode.
5.
Press [<=] button for the previous
menu or press [Home] button to
return to the home screen.
6.
After initial installation, Turning
OFF the Filter Flush Mode puts the
HydroTap into calibration mode.
With subsequent filter changes, the
system reverts to the main menu.
Note:
Run at least 10 Ltrs of
water through to flush the filter
of any excess black carbon
particles (this is normal), before
pressing the Stop button.Once
the filter flush has finished,
press the Stop button to display
the main menu
1.
Press the [MENU] button for main
menu.
2.
Press the [Install] button.
3.
Press the [Filter Reset] button.
4.
In the next screen, press [YES]
button if you want to flush the filter.
Follow the filter flush steps to start
filter flush or press [NO] to cancel
the filter reset program. To set the
filter life or edit filter usage, refer to
section G- Filter.
After replacing the filter, the counters should be reset
2 - Filter Reset
LCD Screen operation - Section C
Loading ...
Loading ...
Loading ...