Loading ...
Loading ...
Loading ...
5
OPERATION
Before use
Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water).
Do not use soap or detergent as the smell may
linger. Dry thoroughly.
Control panel
minmax
A
B
C D
E
ONSUPERALARM
minmax
ON
FG
A - Alarm light - Red
B - Fast freeze switch
C - Fast freeze light - Amber
D - Freezer Pilot light - Green
E - Freezer Thermostat control knob
F - Fridge Pilot light - Green
G - Fridge Thermostat control knob
Control Panel
A. Alarm light
If the alarm light (A) illuminates, it indicates that the
temperature within the freezer has reached a level
where safe food storage is no longer ensured.
When the freezer is first switched on, the alarm light
will stay on until the temperature has dropped to a
safe level for the storage of frozen food.
B. Fast freeze control switch
When you place fresh food in the appliance, press the
fast freeze control switch.
C. Fast freeze light
The fast freeze light is illuminated, to show that the
fast freeze function is working.
D. Freezer pilot light
The pilot light is illuminated to show that the freezer
section is on.
E. Freezer thermostat control knob
Turn the thermostat control knob clockwise to
required setting.
F. Refrigerator pilot light
The pilot light is illuminated to show that the
refrigerator section is on.
G. Refrigerator thermostat control knob
Turn the thermostat control knob clockwise to
required setting.
Start your appliance
Allow the appliance to stand for 2 hours after
installation.
Insert the plug into the wall socket. The pilot light (D)
will illuminate to show that the appliance is on.
Turn the thermostat control (G) to a midway setting.
The pilot light (F) will illuminate. Leave the appliance
for approximately 4 hours for the correct temperature
to be reached before placing food inside.
To switch either section off the appliance turn the
thermostat control to position “
■”.
Temperature control
The temperature within the freezer is controlled by
the thermostat control (E) situated at the top of the
cabinet.
To operate the freezer proceed as follows:
Turn the thermostat control knob beyond the «
■»
position.
When you first start the freezer, we suggest that you
turn the thermostat control to a medium setting. For
easier turning of this control, use a small coin.The
internal temperature of the freezer is automatically
adjusted by the thermostat to ensure safe food
storage.
16
INSTALLATION
Positioning
This appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located at the left on the inside of the
appliance.
The following table shows which ambient
temperature is correct for each climate classification:
SN +10°C to + 32°C
N +16°C to + 32°C
ST +18°C to + 38°C
T +18°C to + 43°C
It should be located in a dry atmosphere, out of
direct sunlight and away from extreme temperature
e.g. not next to a boiler or radiator, or in a very cold
room e.g. an outhouse, where the temperatures may
fall below 10°C (50°F). If these temperatures are
exceeded i.e. colder or warmer, then the appliance
may not operate correctly.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There
must also be at least 100 mm (4”) distance between
the top of the cabinet and any overhanging kitchen
furniture (A). Ideally, the appliance should not be
positioned beneath overhanging furniture (B).
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
close to the wall but must not touch it. DO NOT
install in places with restricted ventilation.
Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers or a tool (see the figure).
D200
Important
IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR,
YOU MUST ENSURE THAT IT IS MADE
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
Important
It must
be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
on “Door reversal”.
NP008
100 mm15 mm
15 mm
A
B
Shelf holders
Your appliance is equipped with shelf retainers that
make it possible to secure the shelves during
transportation.
To remove them proceed as follows:
Raise the shelf from the back, push it in the direction
of the arrow until it is freed and remove the retainers.
B
A
Loading ...
Loading ...
Loading ...