Loading ...
Loading ...
Loading ...
Installation
1. Screw the faucet adapter onto the faucet tap. Check that the connection is secure and that there are no leaks.
2. Connect the six-sided connection of the drain hose to the drain port connection on the back of the dishwasher. Do not over-tighten
or risk damage.
3. Connect the star-shaped connection of the inlet hose to the inlet port on the back of the dishwasher. Do not over-tighten or
risk damage.
4. Connect the circular connection of the drain hose onto the long (bottom) male connection on the quick connect.
5. Connect the circular connection of the inlet hose onto the short (top) male connection on the quick connect.
6. Attach the quick connect onto the faucet adapter by pulling down the outer locking collar on the quick connect while pushing the
quick connect upward onto the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking collar. Check that the connection is secure.
8. Slowly open the hot water line and check for any sign of water leaks in the hose connections. If leaks are found, immediately turn
off the water supply and secure the hose connections.
NOTE: before disconnecting the quick connect from the faucet, relieve the water pressure by first turning off the water line, then
press and hold the red pressure relief button on the quick connect until the water flow stops.
Before operation
1. Check that the dishwasher is on a flat, level surface.
2. Set the inlet valve to an open position.
3. Check that there is no leakage from any of the connections.
4. Check that all wires are securely connected.
5. Check that the power is on.
6. Check that all packaging materials have been removed from the inside of the unit.
Operating the rinse aid dispenser
Check the size of the black dot on the rinse aid level indicator. If the rinse aid level is ¼ capacity or less, refill.
4
Full
¾ full
½ full
¼ full
Empty
To fill the rinse aid dispenser:
1. Open the dispenser, turning the cap left and lifting it out, as seen below.
2. Pour the rinse aid into the dispenser, being careful to not overfill.
3. Replace the cap, turning it right until it is securely in place.
123
Loading ...
Loading ...
Loading ...