Loading ...
Loading ...
Loading ...
7
INSTALLATION AND OPERATING INSTRUCTIONS
INSTALLATION OF YOUR ICE MAKER
Locate the ice maker away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sun-
light may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold am-
bient temperatures may also cause the ice maker not to perform properly.
Plug the ice maker into an exclusive properly installed-grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord.
IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.
SPACE REQUIREMENTS
During transportation, the incline angle of the cabinet should not be over 45°
Do not turn the Ice Maker upside down. Problems could occur in the compressor and sealed system.
The Ice maker should be placed horizontally on a properly leveled surface.
To ensure proper ventilation for your Ice maker allow 6” of space at the back and on each side.
Before using the Ice maker for the first time, please wait 4 hours after positioning it.
Clean the ice shovel, ice basket, water reservoir, and ice scoop frequently.
OPERATING INSTRUCTIONS
Using this portable ice maker requires water. Adding water to this unit can be done in 2 different methods:
MANUAL FILL METHOD
1. Make sure that the ice maker is turned off.
2. Open the top cover and remove the ice basket.
3. Remove any dust or objects that may be in the water reservoir.
4. Fill the water reservoir up to the line marked “____”. Fill with potable or drinking water only.
DIRECT WATER CONNECTION METHOD
The direct water line can be installed into the ice maker for a continuous flow of water, preventing you from
refilling a water reservoir every time you need more ice.
NOTE: For installation, please consult a professional plumber
1. Make sure that the ice maker is turned off.
2. Insert the inlet hose into the water inlet port, shown in Fig. 1a
3. Make sure that the inlet hose if fully inserted to avoid water leakage. See Fig 1b
4. Connect the other end of the hose to your water source. Fig. 1c
5. Hand screw the hose into the water source and be sure to tighten the connection to avoid leaking. Fig. 1d
6. The recommended water pressure is 58 PSI.
ICE MAKING INSTRUCTIONS
1. Turn the unit on by pressing the Power button.
2. Select desired ice cube size by pressing the Size Selector (Small, Medium, or Large)
3. Water will be pumped from the water reservoir to the water tray under the freezing bars. The freezing bars will
start freezing. Once the freezing process is complete, the freezing bars will heat up to drop the ice cubes. Then
the ice shovel will push the ice cubes down to the ice basket.
4. When the unit is used for the first time, discard the first couple batches of ice.
Loading ...
Loading ...
Loading ...