Loading ...
Loading ...
Loading ...
13
Safety Instructions Operating Instructions Care and Cleaning
Troubleshooting Tips Consumer Support
Using the clock, timer and control lockout. ge.com
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Press the
CLOCK
pad.
Press the number pads.
Press the
START
pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Press the
KITCHEN TIMER ON/OFF
pad.
Press the number pads until the
amount of time you want shows in
the display. For example, to set 2
hours and 45 minutes, press
2, 4
and
5
in that order.
If you make a mistake press the
KITCHEN TIMER ON/OFF
pad and
begin again.
Press the
START
pad.
After pressing the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches
:00
, the
control will beep 3 times followed
by one beep every 6 seconds until
the
KITCHEN TIMER ON/OFF
pad
is pressed.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the
KITCHEN TIMER ON/OFF
pad, then
press the number pads until the time you
want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the
KITCHEN TIMER ON/OFF
pad
and then pressing the number pads to
enter the new time you want.
To Cancel the Timer
Press the
KITCHEN TIMER ON/OFF
pad
twice.
Your control will allow you to lock out the press
pads so they cannot be activated when pressed.
To lock/unlock the controls:
Press the
9
and
0
pads at the same
time for 3 seconds, until the display
shows
LOC ON
.
To unlock the control, press the
9
and
0
pads at the same time for
3 seconds, until the display shows
LOC OFF
.
When this feature is on and the press
pads are pressed, the control will beep
and the display will show
LOC ON
.
■
The control lockout mode affects all press
pads. No press pads will work when this
feature is activated.
■
The adjustment will be retained in memory
after a power failure.
Control Lockout
Loading ...
Loading ...
Loading ...