Loading ...
Loading ...
Loading ...
Alternate Procedure
1. Bring the vehicle to a complete stop.
2. With the ignition switch in the ON position, and the
engine OFF or RUNNING, shift the transmission into
NEUTRAL.
3. Move the transfer case switch to the desired position.
4. After the desired position indicator light is on (not
flashing), shift the transmission into gear.
NOTE: Steps 1 and 2 in the “Preferred Procedure” and
the “Alternate Procedure” are requirements for shifting
the transfer case. If these requirements are not met prior
to attempting the shift or while the shift attempt is in
process, then the indicator light will flash, and the
current transfer case position will be maintained. To retry
a shift, move the transfer case switch back to the original
position, make certain all shift requirements have been
met, wait five seconds, and try the shift again.
The ignition switch must be in the ON position for a shift
to take place and for the position indicator lights to be
operable. If the ignition switch is not in the ON position,
then the shift will not take place and no position indicator
lights will be on or flashing.
Selec-Trac姞 II Transfer Case – If Equipped
Operating Information And Precautions
The Selec-Trac威 II active on-demand transfer case pro-
vides four positions:
•
Two-wheel drive (2WD) high range
•
Four-wheel drive Auto (4WD AUTO) high range
•
Neutral (N)
•
Four-wheel drive (4WD) low range
5
STARTING AND OPERATING 327
Loading ...
Loading ...
Loading ...