Loading ...
Loading ...
Loading ...
26. 4WD Indicator — Vehicles Equipped with
Selec-Trac威 II
This light alerts the driver that the vehicle is in
the full-time four-wheel drive auto mode. In
this mode, the system operates with a normal
torque split of 42% front axle and 58% rear axle.
It can redirect up to 100% of torque to the front or rear
axle, if necessary.
27. Odometer Display/Trip Odometer Display
The odometer display shows the total distance the ve-
hicle has been driven. The trip odometer shows indi-
vidual trip mileage. Refer to “Trip Odometer button” for
additional information.
NOTE: U.S. Federal regulations require that upon trans-
fer of vehicle ownership, the seller certify to the pur-
chaser the correct mileage that the vehicle has been
driven. If your odometer needs to be repaired or serviced,
the repair technician should leave the odometer reading
the same as it was before the repair or service. If s/he
cannot do so, then the odometer must be set at zero, and
a sticker must be placed in the door jamb stating what the
mileage was before the repair or service. It is a good idea
for you to make a record of the odometer reading before
the repair/service, so that you can be sure that it is
properly reset, or that the door jamb sticker is accurate if
the odometer must be reset at zero.
Vehicle Odometer Messages
When the appropriate conditions exist, the following
messages will display in the odometer:
ECO ................... Fuel Saver Indicator Off
ECO-ON ................ Fuel Saver Indicator On
door .............................Door Ajar
gATE ...........................Liftgate Ajar
gLASS ......................Flipper Glass Ajar
LoW tirE.....................LowTirePressure
gASCAP .......................Fuel Cap Fault
noFUSE ..........................Fuse Fault
CHAngE OIL ...............OilChange Required
230 UNDERSTANDING YOUR INSTRUMENT PANEL
Loading ...
Loading ...
Loading ...