Loading ...
Loading ...
Loading ...
Problem Possible cause Remedy
The hob deactivates. You put something on the
sensor field .
Remove the object from
the sensor field.
Residual heat indicator
does not come on.
The zone is not hot be‐
cause it operated only for a
short time.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Hob²Hood function does
not work.
You covered the control
panel.
Remove the object from
the control panel.
Automatic Heat Up func‐
tion does not operate.
The zone is hot. Let the zone become suffi‐
ciently cool.
The highest heat setting is
set.
The highest heat setting
has the same power as the
function.
The heat setting changes
between two levels.
Power management func‐
tion operates.
Refer to "Daily use" chap‐
ter.
The sensor fields become
hot.
The cookware is too large
or you put it too near to the
controls.
Put large cookware on the
rear zones if possible.
There is no signal when
you touch the panel sensor
fields.
The signals are deactiva‐
ted.
Activate the signals.
Refer to "Daily use" chap‐
ter.
The flexible induction
cooking area does not heat
up the cookware.
The cookware is in the
wrong position on the flexi‐
ble induction cooking area.
Place the cookware in the
correct position on the flex‐
ible induction cooking
area. The position of the
cookware depends on the
activated function or func‐
tion mode.
Refer to "Flexible induction
cooking area" chapter.
The diameter of the bottom
of the cookware is incor‐
rect for the activated func‐
tion or function mode.
Use cookware with diame‐
ter applicable to the activa‐
ted function or function
mode. Use cookware with
diameter smaller than 160
mm on a single section of
the flexible induction cook‐
ing area.
Refer to "Flexible induction
cooking area" chapter.
comes on.
Automatic Switch Off oper‐
ates.
Deactivate the hob and ac‐
tivate it again.
www.electrolux.com20
Loading ...
Loading ...
Loading ...