Loading ...
Loading ...
Loading ...
10 / EN
Dryer / User Manual
To change the cord:
1. Make sure that the dryer is not plugged
into any power outlet.
B
DO NOT plug end of dryer power
cord into a live receptacle before
connecting dryer power cord
to dryer terminals and closing
junction/splitter box as described
below.
B
DO NOT repair old power
supply cords. Power cord must
be changed only by a qualified
person. There is a risk of electric
shock!
2. Remove the screw from the cover of the
junction box located at the top rear of the
dryer.
3. Remove the red, white and black wire
from the terminal block.
4. Remove the green ground wire from the
ground terminal.
5. Loosen the strain relief clamp holding the
4-wire cable.
6. Thread the 4-wire cable out through the
strain relief clamp.
7. Thread the new 3-wire dryer cord through
the strain relief clamp.
8. Attach the power cord Ground conductor
(the center wire) to the terminal labeled N.
Connect the terminal labeled N and the
Ground terminal labeled G with the supplied
short cable. Tighten the terminals so that
they securely hold the conductors.
9. Attach the two remaining power cord
outer conductors to the 2 terminals labeled
L. Tighten both screws so that the power
conductors are securely held in place.
10. Tighten the strain relief so that the power
cord cannot be moved.
11. Replace the cover on the junction box
and fasten in place.
Power Cable
The dryer is now ready to be plugged into
the 3-wire receptacle of the proper rating.
The receptacle should be located so that the
plug and receptacle will be accessible with
the dryer in its installed position.
3.2 Grounding Instructions
This appliance must be grounded. In
the event of malfunction or breakdown,
grounding will reduce the risk of electric
shock by providing a path of least resistance
for electric current. This appliance is
equipped with a cord having an equipment-
grounding conductor and a grounding
plug. The plug must be plugged into an
appropriate outlet that is properly installed
and grounded in accordance with all local
codes and ordinances.
• Power cord plug must be within easy reach
after installation.
• The voltage and the allowed fuse/breaker
protection are specified in the section
“Technical Specifications”.
• The stated voltage must match your mains
voltage.
• Connection via extension cords or multi-
plugs should not be made.
• The main fuse/breaker and switches must
have a contact distance of minimum 3 mm.
B
A damaged power cable must be
replaced by a qualified electrician.
B
WARNING – Improper
connection of the
equipment-grounding
conductor can result in a
risk of electric shock. Check
with a qualified electrician
or service representative
or personnel if you are
in doubt as to whether
the appliance is properly
grounded. Do not modify
the plug provided with the
appliance: if it will not fit the
outlet, have a proper outlet
installed by a qualified
electrician.
Loading ...
Loading ...
Loading ...