Loading ...
Loading ...
Loading ...
47TROUBLESHOOTING
ENGLISH
Problem Possible Cause Solutions
Washer will not turn
on
Power cord is not properly
plugged in.
Make sure that the plug is plugged securely into a
grounded, 3-prong, 120-VAC, 60-Hz outlet.
House fuse is blown, circuit
breaker has tripped, or power
outage has occurred.
Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualied electrician.
Wash cycle time is
longer than usual
The washer automatically
adjusts the wash time for
the amount of laundry, water
pressure and other operating
conditions.
This is normal. The washer adjusts cycle time
automatically to provide optimal results for the selected
cycle. The time remaining shown in the display is only an
estimate. Actual time may vary.
Bleach does not
dispense
Bleach dispenser cover is not
properly installed.
Make sure that the bleach cover is properly installed and
snapped into place before the beginning of the cycle.
Bleach dispenser is dirty or
clogged.
Lift out the bleach dispenser cover and clean out the
reservoir. Lint and other foreign debris that collects in the
inside the dispenser may prevent proper dispensing of
the bleach.
Premature
dispensing of
bleach
Bleach dispenser lled for
future load.
You cannot store bleach in the dispenser for future use.
The bleach will be dispensed every load.
Incomplete or
no dispensing of
detergent
Detergent compartments
clogged from incorrect lling.
Make sure that detergent and additives are put into the
correct dispenser compartments. For all detergent types,
always make sure that the dispenser drawer is fully
closed before the start of the cycle.
Too much detergent used.
Make sure that the suggested amount of detergent is
used per the manufacturer’s recommendations. You may
also dilute the detergent with water to the maximum ll
line on the compartment to avoid clogging. Use only HE
(High-Efciency) detergent.
NOTE: Always use as little detergent as possible. High-
Efciency washers need very little detergent to achieve
optimum results. Using too much detergent will cause
poor wash and rinse performance and may contribute to
odors in washer.
Insufcient water supply.
Make sure that both hot and cold water faucets are
turned on all the way.
Normal residue.
It is normal for a small amount of detergent to remain
in the dispenser. If this residue builds up it can interfere
with normal dispensing of products. Refer to the cleaning
instructions.
Loading ...
Loading ...
Loading ...