Loading ...
Loading ...
Loading ...
19
After 3 seconds the delayed start indicator "E" blinks. The time-remaining indicator "G" will also blink.
The programme will start when both lights fade.
3 in 1 function
When using "3 in 1" combination products, the rinse-aid lights are no longer relevant. It may be helpful
to select the lowest possible setting for water hardness.
If you decide to switch to using a standard detergent system we advise you to:
1: Rell both the rinse aid compartments.
2: Switch the water hardness setting to the highest possible position and run for three normal cycles
with the appliance left empty.
3: Re-adjust the water hardness setting again according to the conditions for your region.
Reset function
You can use the "Reset" function to stop the wash cycle when running by rotating the dial to "Reset".
The appliance will stop after a few minutes and water has completely drained.
Warning
Do not place the tablets in the cutlery basket as this will result in
poorer wash results. The tablets should be placed in the detergent
compartment.
Cancelling or modifying a cycle
A cycle that is underway can be modified if it has only been running for a short time. Otherwise,
the detergent may have already been used and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be relled (see the paragraph entitled, "Adding
Detergent").
To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled
"Reset function" and select the programme you require (see the paragraph entitled "Switching the
dishwasher ON").
POWER 3 in 1DELAY
HEAVY
NORMAL
LIGHT
GLASSWARE
PRE-RINSE
RINSE
QUICK 30
1
2
3
4
5
6
7
B
A
D F
C
G
E
H
Notice:
3 in 1 or similar tablets should not be used when Heat Wash, Rapid
wash or Soak programmes are selected.
en
Loading ...
Loading ...
Loading ...