Loading ...
Loading ...
Loading ...
Installation information
14
Risk of injury and damage.
This appliance must be built in, oth-
erwise it could tip over.
Keep the appliance door(s) shut until
the appliance has been built in and
secured in its housing in accordance
with the operating and installation in-
structions.
Fire hazard and risk of damage.
The appliance must not be installed
underneath a cooktop.
Installation location
This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your ap-
pliance, please bear in mind that the
energy consumption will increase if in-
stalled near to a heater, a cooker, or
other appliance that gives off heat. Di-
rect sunlight should also be avoided.
The higher the room temperature, the
longer the compressor has to run and
the higher the energy consumption is.
When installing the appliance, please
note:
– The electrical outlet must be easily
accessible in an emergency and not
concealed behind the appliance.
– The plug and power cord must not
touch the back of the appliance as
they could be damaged by vibrations
from the appliance.
– Do not plug other appliances into
electrical outlets behind this appli-
ance.
If installation near a heat source is un-
avoidable, observe the following mini-
mum distances between the appliance
and the heat source:
– At least 1 1/4" (3cm) to electric or
gas stoves
– At least 11 3/4" (30cm) to oil or coal-
based stoves
If it is not possible to observe these
minimum distances, an insulation plate
must be installed between the appli-
ance and the heat source.
Loading ...
Loading ...
Loading ...