Loading ...
Loading ...
Loading ...
7
Check Vent
This indicator will show the status of airflow through the dryer
and the dryer vent system for the dryer’s life. This feature is
available during Sensor and Steam Cycles only. During the
sensing phase at the beginning of the cycle, the Check Vent
light will come on if a blocked vent or low airflow issue is
detected. This light will stay on for the entire cycle. Should
the Check Vent light illuminate, refer to the “Troubleshooting”
section for potential solutions to the issue.
The light will be cleared when selecting a new cycle,
touching Power/Cancel, or opening the door after the cycle
has completed. Although the light will be cleared at the
beginning of a cycle, it will continue to illuminate during the
cycle unless the root cause is resolved.
NOTE: The dryer will continue to operate even while the
indicator is lit, but poor airflow can impact dry times and overall
performance. For more information on maintaining good airflow,
see “Check Your Vent System for Good Airflow.” If there are
other error issues during a cycle, the Check Vent indicator will
not light up. See the “Troubleshooting” section.
This will indicate that the selected cycle has ended and the
load may be removed from the dryer. If Wrinkle Prevent has
been selected, the dryer may continue to tumble the load,
even if “End” is showing in the display.
Control Lock
This will illuminate when the controls are locked.
NOTE: The Control Lock function may be enabled when
recovering from a power failure. To unlock the control, touch
and hold STEAM for at least 3 seconds.
Connected
This will illuminate when the dryer is connected to the internet.
Smart Delay
This will illuminate when a smart delay is in effect: the operation
of the dryer has been delayed to a time when lower utility rates
are in effect.
CONNECTIVITY
Use to select available connectivity options for your dryer.
Not all cycles and options are available on all models.
Download the Whirlpool
®
app and follow the instructions
to connect your dryer to your home Wi-Fi network. You may
also visit www.whirlpool.com/connect.
WiFi Connect
Touch and hold WIFI CONNECT for 3 seconds during
the initial connection of the dryer to your home Wi-Fi
network. If the dryer is in a Smart Delay, touch WIFI
CONNECT to override the delay and begin a dry cycle
immediately.
Remote Enable
To start a dryer cycle remotely from the Whirlpool
®
app,
touch REMOTE ENABLE. The Remote Enable status
indicator will begin blinking. Select the desired cycle,
cycle settings, and options. Touch and hold START/
PAUSE to set the Remote Enable. The Remote Enable
status indicator will be solidly lit.
NOTE: Any interaction with the dryer once a Remote
Enable has been set will cause the Remote Enable
to cancel.
6
CYCLE AND CONNECTED
STATUS INDICATORS
The Cycle Status Indicators show the progress of a cycle.
The Connected Status Indicators show the connected status.
Not all indicators are available on all models.
Sensing
The Sensing indicator will light during Sensor Cycles to
indicate that the moisture sensor on the dryer is operating.
This indicator will not light during Timed Cycles or options
such as Wrinkle Prevent.
Wet
The load is still wet and/or the cycle just started.
Damp
The load still has moisture remaining, a good point
in the cycle to remove a garment to air dry or iron.
Cool Down
The dryer has finished drying with heat and is now tumbling
the load without heat to cool it down and reduce wrinkling.
7
:
Sensing
Cool Down
Check Vent
Wet
Damp
Appearance may vary.
Loading ...
Loading ...
Loading ...