Loading ...
Loading ...
Loading ...
7
3. Remove the plastic insert on the opposite side of the
refrigerator door.
4. Attach the top door bracket to this side of the refrigerator, using
the screws previously removed. Replace the top plastic hinge
cover.
5. Remove the adjustable foot at the bottom of the refrigerator,
and set aside.
6. Unscrew the two screws holding the bottom door hinge, and
carefully move it across to the opposite side.
7. Fit the door to the top and bottom hinge before fixing it into
position. Care must be taken, as the door will be loose.
8. Screw the adjustable foot to the opposite side of the fridge.
Set the unit back down onto a flat, even surface. Check that the door opens and shuts properly and
fully closes after completing the door reversal.
NOTE: The unit must now sit upright for at least three hours before turning the unit on.
Electrical connection
A three-hole, well-grounded socket with a fuse is required to operate this unit. Never ground the
cooler through a gas pipe, tap water pipe, or the grounded wire of a single-phase power supply. The
power supply should be 110 to120 VAC / 60Hz, and requires a voltage stabilizer of over 500VA if the
power supply is out of this range. Never share the same circuit with other appliances.
NOTE: If the unit is unplugged or the power supply is interrupted, wait at least five minutes before
reconnecting to a power supply.
Before Storing Cosmetics
Connect the unit to a power supply. The LED will light by turning on the switch fixed on the panel
inside cabinet. In 30 minutes, the temperature inside the cabinet should have cooled down,
indicating normal operation.
Loading ...
Loading ...
Loading ...