Loading ...
2 English
APPROVED FOR RESIDENTIAL APPLIANCES
FOR RESIDENTIAL USE ONLY
READ AND SAVE THESE INSTRUCTIONS
PLEASE READ ENTIRE INSTALLATION GUIDE BEFORE PROCEEDING.
INSTALLATION MUST COMPLY WITH ALL LOCAL CODES.
IMPORTANT: Save these Instructions for the Local Electrical
Inspector’s use.
INSTALLER: Please leave these Instructions with this unit for
the owner.
OWNER: Please retain these instructions for future
reference.
Important Safety Instructions
WARNING
Turn off power circuit at service panel and lock out panel before installing
this kit to the appliance.
Installation must comply with all local codes.
CAUTION
Remove the carton carefully. Wear gloves to protect against sharp edges.
Installation
Tools and Parts
Part Qty Part Qty
Air deector
1
Charcoal Filter
2
4.2x8 mm
4
Plastic grid
1
4.5x13 mm
2
Recirculating Kit
If it is not possible to vent cooking fumes and vapors to the outside, the
range hood can be used in the non-vented (recirculating) version, using a
charcoal lter and an air deector for the Wall hoods or a charcoal lter and
a plastic grid for the Undercabinet hoods. Recirculation Kit is available from
the dealer or an authorized parts distributor.
Air Deector Installation on Wall Hoods
• Assemble the air deector with the duct cover bracket using
(4) 4.2 x 8 mm screws.
C
B
A
A. Assembly screws
B. Air deector
C. Duct cover bracket
• Measure from the bottom of the air deector to the bottom of the
hood outlet.
X
A
C
B
D
E
A. Air deector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
• Cut the duct to the measured size “X.”
• Remove the air deector.
• Slide the duct onto the bottom of the air deector.
• Place the assembled air deector and duct over the exhaust outlet
from the hood.
• Reassemble the air deector to the duct cover bracket with the four
assembly screws.
• Use duct tape or vent clamps to seal the deector and the exhaust
outlet from the hood.
Loading ...
Loading ...
Loading ...