Loading ...
Loading ...
Loading ...
49-80589-7 15
INSTALLATION INSTRUCTIONS
19
INSTALL LIGHT BULB
NOTE: A light bulb is not shipped with the hood.
Obtain one locally. Purchase and install a type
A15 incandescent light bulb with an ordinary
screw base, not more than 60 Watts, or a type
A17 or T2 Compact Fluorescent (CFL) light bulb
with an ordinary screw base, not more than 13
Watts. NOTE: Use only incandescent bulbs in
models RN328, JN327, JN328 and JV338.
IMPORTANT: For installation, handling and
disposal precautions, refer to the fluorescent
bulb packaging literature.
When using an energy saving bulb in your GE
Appliances hood, make sure you use either:
22
REPLACE WIRING COVER
23
REPLACE FILTER
Make sure fan blade turns freely and replace
the filter. NOTE: Install the metal grease filter if
ducted or the charcoal filter if recirculated.
The installation is complete. Turn on power at
service panel, and test for proper operation.
TROUBLESHOOTING CHECKLIST
If the hood seems to be operating at high speed
when the control is not set on high, or if ventilation
seems inadequate, check the following:
❏ Knockouts not removed from hood.
❏ Damper blade not opening.
❏ Reduced airflow because the duct is too small or
the duct length is too long.
❏ The duct is blocked.
❏ Undersized or restrictive wall or roof cap.
If the hood seems to make excessive noise:
❏ Fan may be hitting the filter. Turn off the fan and
remove the filter. Bend the filter down slightly
in the center (into a dome shape) to allow fan
clearance. Reinstall and adjust as needed.
The fan does not work but the lights do:
❏ Switch power off at the service panel and lock
the service disconnecting means to prevent
power from being switched on accidentally.
When the service disconnecting means cannot
be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
❏ Check the wiring connections. See the
CONNECT WIRING section in these Installation
Instructions.
20
FOLLOW ELECTRICAL CODE
Complete the electrical wiring according to
National Electrical Code and local codes.
NOTE: This hood must be permanently grounded.
Connect house wiring (120 VAC) to hood wiring.
21
CONNECT WIRING
Connect house black to hood black wire,
house white to
hood white wire and
house ground under
green ground screw.
Securely tighten the
strain relief clamp
onto the house wiring.
WARNING
IMPROPER CONNECTION
OF ALUMINUM HOUSE WIRING TO
THESE COPPER LEADS CAN RESULT
IN A SERIOUS PROBLEM. USE ONLY
CONNECTORS DESIGNED FOR JOINING
COPPER TO ALUMINUM AND FOLLOW
THE MANUFACTURER’S RECOMMENDED
PROCEDURE CLOSELY.
Installation Instructions
GE Long Life Energy
Smart
™
Spiral
®
T2
Product Code: 85383
Description:
FLE13HT2/2/SW/CD
GE Long Life Energy
Smart
™
A17
Product Code: 47486
Description:
FLE11/2/A17XL/CD
Available at
www.gelighting.com
or
Green
ground
screw
Wiring cover
Metal grease filter or charcoal filter
Loading ...
Loading ...
Loading ...