Loading ...
Loading ...
Loading ...
49-80589-7 11
INSTALLATION INSTRUCTIONS
Installation Instructions
2
REMOVE EXHAUST ADAPTOR
,IH[KDXVWLQJYHQWLQJXVLQJWKHƎ[
ƎUHFWDQJXODUGXFW²RSWLRQDOIRU-9
JV248, JV338, JV347, JV348, JV367 and
AV447 models only:
Remove the exhaust adaptor from the inside of
the hood. Set it aside along with its mounting
screws.
5
REMOVE WIRING COVER
Remove the wiring cover from inside the hood.
Set the cover and its mounting screws aside.
6
REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring
knockout as needed and install an approved
strain relief clamp.
7
REMOVE DUCT KNOCKOUT
If recirculating, non-vented ductless (JN327,
JN328 and RN328, and optional for JV247,
JV248, JV347, JV348, JV367 and AV447
models only), skip to Step 11 D and proceed.
Using a flat-blade screwdriver, remove the
appropriate duct knockout from the top or
back of the hood.
3
REMOVE FILTER
Remove the shipping tape holding the metal
grease filter in place. Pull down on the center
of the front edge of the filter. The filter will then
slip out of the retaining tabs on the back.
4
REVERSE THE BAFFLE FOR DUCTED
INSTALLATIONS ONLY
(JV247, JV248,
JV347, JV348, JV367 and AV447 models)
If the hood is to be recirculated, skip to the
next step. Remove the baffle from the top of
the hood. Reinstall the baffle so the short side
marked “VENTED” is visible. The long side of
the baffle should be inside the hood.
3
1
ø4s x 10s
rectangular
exhaust
adaptor
and screws
Metal grease filter
“VENTED” is visible
Wiring
cover
Strain relief
clamp
Back
knockout
Top
knockout
Strain relief
clamp
3
1
ø4s x 10s Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
7s Round vertical discharge.
Remove circular duct
knockout only.
3
1
ø4s x 10s Rectangular horizontal
discharge. Remove rear
rectangular duct knockout only.
Loading ...
Loading ...
Loading ...