Loading ...
Loading ...
Loading ...
Installation
34
Lubrication of gas taps
Over time the gas taps may become difficult
to turn and get blocked. Clean them
internally and replace the lubrication
grease.
Burner and nozzle characteristics table
5.4 Electrical connection
General information
Check the grid characteristics against the
data indicated on the plate.
The identification plate bearing the
technical data, serial number and brand
name is visibly positioned on the appliance.
A copy of the identification plate is included
in the booklet. It should be applied to an
adjacent surface or this instruction manual.
Do not remove this plate for any reason.
Perform the ground connection using a wire
that is 20 mm longer than the other wires.
The greasing of the gas taps
should be performed by a
specialised technician.
1 ULPG 2.75 kPa AUX SR R UR
Nominal gas consumption (MJ/h)
3.9 6.3 10.8 15.0
Injector (1/100 mm)
54 68 88 105
2 NG 1.0 kPA AUX SR R UR
Nominal gas consumption (MJ/h)
3.9 7.5 12 15.8
Injector (1/100 mm)
90 120 155 185
Power voltage
Danger of electrocution
• Have the electrical connection
performed by authorised technical
personnel.
• Use personal protective equipment.
• The appliance must be connected to
earth in compliance with electrical
system safety standards.
• Disconnect the main power supply.
• Do not pull the cable to remove the
plug.
• Use cables withstanding a temperature
of at least 90°C.
• The tightening torque of the screws of
the terminal supply wires must be 1.5 - 2
Nm.
Loading ...
Loading ...
Loading ...