Loading ...
Loading ...
Loading ...
14
FINAL INSTALLATION
4. Install the blade arm (R) to the underside of the motor
assembly (G) with motor screws (T) previously removed
(Step 6, page 8). Tighten with Phillips screwdriver.
Repeat for each blade arm (R).
5. Remove one of the adapter plate screws (AC) from
the adapter plate (AB), and loosen (do not remove) the
other two screws.
Insert the wires from the motor assembly (G) through
the hole in the switch housing (H). Then, attach the
switch housing (H) to the adapter plate (AB) by twisting
the switch housing (H) until the loosened adapter plate
screws (AC) engage the keyholes on switch housing (H).
Re-install the third adapter plate screw (AC) into the
closed hole in the switch housing (H) and securely
tighten all three adapter plate screws (AC).
Connect the 9-pin connector from the fan to the 9-pin
connector from the switch housing (H).
Note: If you wish to install the fan without the light kit (K),
proceed to Step 11.
6. To install the light kit (K), remove the preassembled
nial (M), nial cap (L), hex nut (V) and rubber washer
(W) from the light kit (K).
4
R
T
G
6
5
K
AC
AB
G
H
W
V
L
M
9-pin Connectors
Loading ...
Loading ...
Loading ...