Loading ...
Loading ...
Loading ...
20
INSTALLING THE WATER LINE (cont.)
Installation Instructions
CONNECT THE TUBING TO THE
REFRIGERATOR
TURN THE WATER ON AT THE
SHUTTOFF VALVE
PLUG IN THE REFRIGERATOR
START THE ICEMAKER
Place the compression nut and ferrule (sleeve) onto the end
of the tubing as shown. On GE SmartConnect™ Refrigerator
Tubing kit, the nuts are already assembled to the tubing.
Insert the end of the tubing into the water valve connection
as far as possible. While holding the tubing, tighten the
fitting.
For plastic tubing from a GE SmartConnect Refrigerator
Tubing kit , insert the molded end of the tubing into the
refrigerator connection and tighten compression nut until
it is hand tight , then tighten one additional turn with a
wrench. Overtightening may cause leaks.
Fasten the tubing into the clamp provided to hold it in a
vertical position. You may need to pry open the clamp.
Reattach the compressor compartment access cover.
Tighten any connections that leak.
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
Set the icemaker feeler arm to the ON (down) position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below.
It will then begin operation automatically, if the
icemaker feeler arm is in the ON (down) position.
NOTE: In lower water pressure conditions, the water
valve may turn on up to 3 times to deliver enough
water to the icemaker.
9
10
11
12
1/4” Tubing
Tubing Clamp
1/4”
Compression
Nut
Smart
Connect ™
Tubing
Refrigerator
Connection
Ferrule
(sleeve)
Feeler arm in ON
(down) position
Loading ...
Loading ...
Loading ...