Loading ...
Loading ...
Loading ...
Problem Possible Causes What To Do
Control panel lights Time too long between Each button must be touched within 30 seconds of the others.
go off when you’re touching of selected buttons To relight, touch any button again or open the door and
setting controls unlock (top control).
Water standing in Air gap is clogged Clean the air gap. See the Care and cleaning section.
the bottom of the tub
High drain loop or air Refer to the Installation Instructions for proper drain line installation.
gap not installed
Water won’t pump Drain is clogged If you have an air gap, clean it. See the Care and cleaning section.
out of the tub
If the dishwasher drains into a disposer, run disposer clear.
Check to see if your kitchen sink is draining well. If not, you
may need a plumber.
Steam This is normal Warm, moist air comes through the vent during drying and when
water is being pumped out. This is necessary for drying.
Sanitized or Cycle The door was opened and the Do not interrupt the cycle by opening the door during the wash cycle.
Sanitized light does cycle was interrupted during
not illuminate at the final rinse
end of the cycle
The incoming water Raise the water heater temperature to between 120°F and 150°F.
temperature was too low
Noise Normal operating sounds: These are all normal. No action is required.
Detergent cup opening
Water entering dishwasher
The motor stops and starts at
various times during the cycle
Spray arms start and stop at
various times
Drain pump sounds during
pump out
Drain pump starts and stops
several times during each drain
Rattling dishes when the spray Make sure dishes are properly loaded. See the Loading the
arm rotates dishwasher section.
Rattling silverware against door Tall utensils may be placed in the upper rack to avoid bumping against
during wash inner door during wash cycle.
A white film on This problem is likely caused To remove the white film, run your dishes through a dishwasher cycle with
glassware, dishware by a low quality phosphate-free citric acid. Use a WD35X151 citric acid kit found online. Otherwise, use Lemi
and the interior dishwasher detergent Shine (WX10X10019) found at your local grocery store.
Pour the citric acid in the detergent cup and close the cover. Place the filmed
but otherwise clean glassware and dishware in the dishwasher. Leave
silverware and other metal items out of the dishwasher. Turn the dishwasher
on and let it run through a complete cycle without detergent. The glassware,
dishware, and dishwasher should come out film free. Alternatively,
a vinegar rinse may be used. Pour 1 cup of vinegar into dishwasher just after
the detergent cup opens and let the dishwasher complete its cycle.
This may be repeated several times a year as needed
The use of a rinse agent such as Cascade
®
Rinse Aid may help minimize
a repeat build up of film. Also, the use of a highly rated detergent
such as Cascade
®
Platinum Pacs will help prevent film build-up.
Before you call for service…
28
Loading ...
Loading ...
Loading ...