Loading ...
Loading ...
Loading ...
11
The cappuccino is ready. Sweeten to taste and if desired,
sprinkle the froth with a little cocoa powder.
Please note:
to prepare more than one cappuccino, rst make all the
coees then at the end prepare the frothed milk for all the
cappuccinos.
to exit the steam function, press any button. The lights
and ash to indicate that the temperature is
too high to make coee (see section “Cooling the boiler”).
You should not deliver steam for more than
60 seconds.
Important:
For hygiene reasons, the cappuccino maker should always be
cleaned after use.
Proceed as follows:
1. Turn the steam dial to deliver a little steam for a few
seconds (points 2, 4 and 5 of the previous section).
This causes the cappuccino maker to deliver any milk left in
its circuits. Press the ON/OFF button to turn the appliance
o.
2. With one hand, hold the cappuccino maker tube rmly,
with the other, release the cappuccino maker by turning it
clockwise, then pull o downwards (g. 16).
3. Remove the rubber steam connection nozzle from the
spout by pulling it downwards (g. 17).
4. Wash the cappuccino maker and steam connection nozzle
thoroughly with warm water (g. 18).
5. Check the hole shown by the arrow in g. 18 is not blocked.
6. Put the steam connection nozzle back, pressing upwards to
insert it onto the steam tube.
7. Replace the cappuccino maker by pushing upwards and
turning anticlockwise.
Cooling the boiler
To make coee again immediately after frothing milk, the boiler
must rst be cooled or the coee will be burnt.
Proceed as follows:
place a container under the cappuccino maker;
open the steam dial to deliver hot water and cool the
boiler;
hot water delivery is interrupted automatically when the
boiler is cool. When the pump stops operating and no more
water is delivered, close the steam dial.
The coee maker is now ready for use.
HOT WATER
1. Turn the appliance on by pressing the ON/OFF button (g.
4). Wait for the coee lights to come on steadily.
2. Place a recipient under the cappuccino maker.
3. Turn the dial to the
position. Hot water is delivered
from the cappuccino maker.
4. To stop hot water delivery, close the dial and press any
button.
You should not deliver hot water for more
than 60 seconds.
CLEANING
Danger!
Before cleaning the outside of the appliance, turn it o, unplug
from the mains socket and allow to cool.
Cleaning the drip tray
Important!
The drip tray is tted with a level indicator (red) showing the
level of water it contains (g. 19).
Before the indicator protrudes from the cup tray, the drip
tray must be emptied and cleaned, otherwise the water may
overow the edge and damage the appliance, the surface it
rests on or the surrounding area.
1. Remove the drip tray (g. 20).
2. Remove the cup tray, empty the water and clean the drip
tray with a cloth, then reassemble the drip tray.
3. Put the drip tray back in place.
Cleaning the coee lters
Clean the coee lters regularly by rinsing under running water.
Make sure the holes are not blocked. If necessary, clean with a
pin (g. 21).
Cleaning the boiler outlet
After every 200 coees, rinse the boiler outlet by delivering
about 0.5 l of water from the boiler outlet (press the coee
button without using ground coee).
Other cleaning operations
1. Do not use solvents or abrasive detergents to clean the
coee maker. Use a soft damp cloth only.
2. Clean the lter holder cup regularly.
Cleaning the water tank
Clean the water tank regularly (about once a month) with a
damp cloth and a little mild washing up liquid.
Danger!
During cleaning, never immerse the coee maker in water. It is
an electrical appliance.
Loading ...
Loading ...
Loading ...